Frigidaire FARE4044MW important safety instructions Care and Cleaning, Inside

Page 13

WARNING

FIRE HAZARD

A clothes dryer produces combustible lint. The dryer must be connected to an outdoors exhaust. Regularly inspect the outdoor exhaust opening and remove any accumulation of lint around the opening and in the surrounding area.

IMPORTANT

Clean the lint filter after every load.

IMPORTANT

Do not store or place laundry products on top of dryer at any time. They can damage the finish or controls.

CARE AND CLEANING

WARNING

To reduce risk of fire or serious injury to persons or property, comply with the basic warnings listed in the Important Safety Instructions and those listed below.

Before cleaning the dryer interior, unplug the electrical power cord to avoid electrical shock hazards.

Do not use any type spray cleanser when cleaning the dryer interior. Hazardous fumes or electrical shock could occur.

INSIDE

Clean the lint filter after every load. Lint build-up on the filter restricts air flow, which causes longer drying times. The filter is located at the bottom of the door opening. Re- move by pulling straight up. Remove the lint and replace the filter.

Occasionally a waxy build-up may form on the lint filter and/or moisture sensing bars from using dryer-added fabric softener sheets. To remove this build-up, wash them with warm, soapy water. Dry the filter thoroughly and replace. Do not operate the dryer without the lint filter in place.

If the dryer drum becomes stained from noncolorfast fabrics, clean the drum with a damp cloth and a mild liquid household cleanser. Remove cleanser residue before dry- ing the next load.

Every 18 months an authorized servicer should clean the dry- er cabinet interior and exhaust duct. These areas can collect lint and dust over time. An excessive amount of lint build-up could result in inefficient drying and possible fire hazard.

OUTSIDE

Clean the cabinet with mild soap and water. Never use harsh, gritty or abrasive cleansers.

If the cabinet becomes stained, clean with diluted chlo- rine bleach (1 part bleach to 8 parts water). Rinse several times with clear water.

Remove glue residue from tape or labels with a mixture of warm water and mild detergent. Or, touch residue with the sticky side of the tape or label.

When cleaning chrome parts use a window cleaner with ammonia or mild soap and water.

Before moving the dryer, place a strip of cardboard or thin fiberboard under the front leveling legs to prevent damage to the floor.

13

Image 13
Contents Use &Care Important Safety Instructions Electric Dryer Protect Children Normal Operating Sounds Operating InstructionsOperating Your Dryer Prepare load for dryingSelect the appropriate cycle and settings for each load Check that the lint filter is clean and in placeLoad the dryer and close the door Start the cycleFor best results Cycle SelectionAuto Dry Cycles Initial Calculating EstimatedNormal CasualHeavy duty TowelsCycle Settings For best results Cycle Options Dryer Settings Chart Other Features Inside Care and CleaningCommon Drying Problems Solutions to Common ProblemsOccurrence Possible Cause Solution Avoid Service ChecklistWarranty Periods Major Appliance Warranty Information