Hotpoint WDPG 9640 Installation, Unpacking and levelling, Electric and water connections

Page 2

Installation

 

! Keep this instruction manual in a safe place

GB

for future reference. Should the appliance

 

be sold, transferred or moved, make sure

 

the instruction manual accompanies the

 

washer-dryer to inform the new owner as to its

 

operation and features.

 

! Read these instructions carefully: they contain

 

vital information on installation, use and safety.

 

Unpacking and levelling

unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measured according to the worktop, must not exceed 2°.

Levelling your appliance correctly will provide it with stability and avoid any vibrations, noise and shifting during operation. If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room for ventilation beneath the washer-dryer.

Unpacking

!This is a separate part of the polystyrene base and should be removed with the base.

!IMPORTANT check when unpacking your machine.

Electric and water connections

Connecting the water inlet hose

1. Connect the supply pipe by screwing it to a cold water tap using a 3/4 gas threaded connection (see

figure).

Before performing the connection, allow the water to run freely

1.Unpack the washer-dryer.

2.Check whether the washer-dryer has been damaged during transport. If this is the case, do not install it and contact your retailer.

3.Remove the 4

protective screws and

the rubber bush with

the respective spacer, situated on the rear of the appliance (see also the installation leaflet).

4. Seal the gaps

using the plastic plugs

provided.

5. Keep all the parts: you will need them again if the washer-dryer needs to be moved to another location.

!Packaging materials are not children’s toys.

Levelling

Your machine may make a considerable amount of noise if the two front feet have not been adjusted correctly.

1. Install the washer- dryer on a flat sturdy floor, without resting it up against walls,

cabinets or anything else.

2. If the floor is not perfectly level, compensate for any

until it is perfectly clear.

2. Connect the other end of the water inlet hose to the washer- dryer, screwing it onto the appliance’s cold water inlet, situated on the top right-hand side on the rear of the appliance (see figure).

3.Make sure there are no kinks or bends in the hose.

!The water pressure at the tap must be within the values indicated in the Technical details table (on the page 5).

!If the water inlet hose is not long enough, contact a specialist store or an authorised serviceman.

!Ensure that the supply taps are allowing water through. Old taps may seize in the closed position and thus prevent water reaching the machine.

!Never use second-hand or old inlet hoses; use the products supplied with the machine.

2

Image 2
Contents Wdpg Contents Instructions for useElectric and water connections InstallationUnpacking and levelling Replacing the fuse First wash cycle Blue Neutral N Brown Live L Green & Yellow Earth E2006/95/EC Low Voltage 2002/96/EC Technical dataMaximum pressure Care and maintenance Disposal Precautions and tipsGeneral safety Opening the porthole door manuallyDescription of the washer-dryer Control panelDisplay How to run a wash cycle or a drying cycle Wash options Wash cycles and optionsTable of wash cycles Preparing the laundry Detergents and laundryDetergent dispenser drawer Special wash cyclesPossible causes / Solutions TroubleshootingProblem Page GuaranteeGB AssistanceAfter Sales Service 195105690.01