Hotpoint wdd960 manual First wash cycle, U E Neutral N O W N Live L Green & Yellow Earth E

As the colours of the wires in the lead may not

GB	correspond with the coloured markings identifyng
	the terminals in your plug, proceed as follows:
	Connect Green & Yellow wire to terminal marked E
	or	or coloured Green or Green & Yellow.
	Connect Brown wire to terminal marked L or
	coloured Red.
	Connect Blue wire to terminal marked N or coloured
	Black.
	If a 13 amp plug (BS 1363) is used it must be fitted
	with a
	13 amp fuse, either in the plug or adaptor or at the
	distribution board.
	If you are in any doubt the electrical supply to your
	machine, consult a qualified electrician before use.
	How to connect an alternative plug:
	The wires in this mains lead are coloured in
	accordance with the following code:
	B L U E		NEUTRAL (N)
	B R O W N		LIVE (L)
	GREEN & YELLOW		EARTH (E)

Disposing of the appliance:

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

GREEN &

YELLOW

BROWN	13 ampere fuse
BLUE	CROSS-BAR
	CORD GRIP

Warning! The company denies all liability if and when these norms are not respected.

The first wash cycle

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, using the wash cycle .

!The Washer-dryer should not be installed in an outdoor environment, not even when the area is sheltered, because it may be very dangerous to leave it exposed to rain and thunderstorms.

!When the Washer-dryer is installed, the mains socket must be within easy reach.

!Do not use extensions or multiple sockets.

!The power supply cable must never be bent or dangerously compressed.

!The power supply cable must only be replaced by an authorised serviceman.

"