Hotpoint WDUD 10760 instruction manual First wash cycle, Disposing of the appliance

GB As the colours of the wires in the lead may not correspond with the coloured markings iden- tifying the terminals in your plug, proceed as follows:

Connect Green & Yellow wire to terminal marked E or or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked L or coloured Red.

Connect Blue wire to terminal marked N or coloured Black.

If a 13 amp plug (BS 1363) is used it must be fitted with a

13 amp fuse, either in the plug or adaptor or at the distribution board.

If you are in any doubt regarding the electrical supply to your machine, consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance with the following code:

BLUE		NEUTRAL (N)
BROWN		LIVE (L)
GREEN & YELLOW		EARTH (E)
GREEN &
YELLOW
BROWN	13 ampere fuse
BLUE	CROSS-BAR
	CORD GRIP

!The power supply cable must only be repla- ced by an authorised serviceman.

Warning! The company denies all liability if and when these norms are not respected.

The first wash cycle

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, using the programme “Auto Clean” (see “Cleaning the washer-dryer”).

Disposing of the appliance:

When disposing of the appliance please re- move the plug by cutting the mains cable as close as possible to the plug body and dispo- se of it as described on the previous page.

!The washer-dryer should not be installed in an outdoor environment, not even where the area is sheltered, because it may be very dan- gerous to leave it exposed to damp, rain and thunderstorms.

!When the washer-dryer is installed, the mains socket must be within easy reach.

!Do not use extensions or multiple sockets.

!The power supply cable must never be bent or dangerously compressed.

4