Hotpoint WDUD 10760 instruction manual Description of the washer-dryer, Control panel

Page 8

Description of the washer-dryer

 

Control panel

GB

ON/OFF

 

 

button

WASH

Detergent dispenser drawer CYCLE SELECTOR

buttons

MYCYCLE

button

ANTI ALLERGIC RINSE

button

CLEANING ACTION

button

DISPLAY

FUNCTION

buttons

DELAY

TIMER

button

DRY

button

START/PAUSE

button with indicator light

TEMPERATURE

button

CHILD LOCK

button

Detergent dispenser drawer: used to dispense deter- gents and washing additives (see “Detergents and laundry”).

ON/OFF button : press this briefly to switch the ma- chine on or off. The START/PAUSE indicator light, which flashes slowly in a green colour shows that the machine is switched on. To switch off the washer-dryer during the wash cycle, press and hold the button for approximately 3 seconds; if the button is pressed briefly or accidentally the machine will not switch off. If the machine is switched off during a wash cycle, this wash cycle will be cancelled.

WASH CYCLE SELECTOR buttons: used to set the desired wash cycle (see “Table of wash cycles”).

MYCYCLE button: press and hold the button to store a cycle with your own set of preferences in the memory of the machine. To recall a previously stored cycle, press the MY CYCLE button.

FUNCTION buttons: press the button to select the desired function. The corresponding indicator light on the display will switch on.

CLEANING ACTION button: to select the desired wash intensity.

ANTI ALLERGIC RINSE button : press to select the desired rinse type.

DRY button: press to set a drying cycle.

TEMPERATURE button: press to decrease the tempera-

ture: the value will be shown on the display.

CHILD LOCK button: to activate the control panel lock, press and hold the button for approximately 2 seconds. When the symbol is illuminated, the control panel is locked (apart from the ON/OFF button). This means it is possible to prevent wash cycles from being modified accidentally, especially where there are children in the home. To deactivate the control panel lock, press and hold the button for approximately 2 seconds.

DELAY TIMER button: press to set a delayed start time for the selected wash cycle. The delay time will be shown on the display.

START/PAUSE button with indicator light: when the gre- en indicator light flashes slowly, press the button to start a wash cycle. Once the cycle has started the indicator light will remain lit in a fixed manner. To pause the wash cycle, press the button again; the indicator light will flash in an orange colour. If the symbol is not illuminated, the door may be opened. To start the wash cycle from the point at which it was interrupted, press the button again.

Standby mode

This washer-dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the ON-OFF button briefly and wait for the machine to start up again.

Consumption in off-mode: 0.5 W

Consumption in Left-on: 8 W

8

Image 8
Contents Wdud Contents Instructions for useElectric and water connections InstallationUnpacking and levelling Replacement fuse covers Replacing the fuseRemoving the plug Disposing of the plugFirst wash cycle Disposing of the applianceTechnical data Button using a loadCare and maintenance Precautions and tips General safetyDisposal Opening the porthole door manuallyDescription of the washer-dryer Control panelDisplay How to run a wash cycle or a drying cycle Wash functions Wash cycles and functionsTable of wash cycles Detergents and laundry Detergent dispenser drawerPreparing the laundry Special wash cyclesPossible causes / Solutions TroubleshootingProblem Machine vibrates a lot during GuaranteeGB AssistanceAfter Sales Service 195109922.03