More and more important
Your safety and that of your children
Read these indications and all the information in this manual carefully: they are an important source, not only of numerous useful tips, but also of vital information on safety, use and maintenance.
1. Margheritashould not be |
installed in an outdoor |
environment, not even |
when a roof shelters the |
area, because it may be |
very dangerous to leave it |
exposed to rain and |
thunderstorms. |
5.Never touch the washer- dryer when barefoot or with wet or damp hands or feet.
6.Never use extensions or multiple plugs, which are particularly dangerous in humid environments. The power supply cable must never be bent or dangerously compressed.
7.Neveropenthedetergent dispenser while the appliance is functioning; do not use hand wash detergent because the abundance of foam could damage its internal parts.
8. Never pull on the plug or | |
the | |
disconnect it from the wall | |
socket: it is extremely | |
dangerous. |
|
9. While the appliance is | |
functioning, do not touch | |
the drain water | as it |
could reach very | high |
temperatures. | The |
appliance door, during | |
wash cycles, tends to | |
become heated; keep it | |
out of children’s reach. | |
Never force the washer- | |
dryer door because this |
2. It must only be used by |
adults and exclusively for |
washig clothes following |
theinstructionsprovidedin |
this manual. |
3. Shouldithavetobemoved, |
proceed with the help of |
two or three people and |
handle it with the utmost |
care. Never try to do this |
alone, because the |
appliance is very heavy. |
4. Before loading the washer- |
dryer, make sure the |
drum is empty. |
I only want an authorised specialised technician with original Ariston spare parts!
could damage the safety | |
block on the | opening, |
which serves to protect | |
from accidental openings. | |
10. In case of malfunctio- | |
ning, first close the | |
water tap and unplug the | |
appliance from the wall | |
socket; do not under any | |
circumstances | touch |
internal parts in order to | |
attempt repairs. |
|
How to change the power supply cable
(For this operation we suggest you contact a qualified engineer)
The Margherita power supplycableisspecialand can be purchased
exclusively from authorised
To replace the cable:
1.Make sure that Mar- gherita is switched off and unplugged.
2.Remove the covering lid by unscrewing the two screws I, and then pull it towards you [fig. 3].
3.Disconnect the wires from the radio interference suppressor F [fig. 4] noting as to their position (Blue=N wire; Brown=L wire) leaving the earth wire until last .
N.B.: letters L, N and the symbol are indicated on the radio interference suppressor.
4.Remove the upper part of the cable slightly from the back panel of the appliance, pull the power supply cable upwards and take it out [fig. 5].
To connect the new power supply cable, reverse the procedure.
To put the covering lid back on, rest it on the washer- dryer [fig. 6] and let it slide forwards until the hooks situated on the front slide into the special slots formed into the control panel and tighten the screws back on.
I |
Fig. 3
N |
L |
F |
Fig. 4 | Fig. 5 |
Fig. 6
Margherita - Iinstructions for installation and use 14