Ariston ARMF 125 manual First wash cycle, Technical data

Connecting the drain hose

￿Avoid using any extension cord or multiple socket

outlet. GB

65 - 100 cm

Connect the drain hose, without bending it, to a drainage duct or a wall drain located at a height between 65 and 100 cm from the floor;

￿ The cable should not be bent or compressed.

CAUTION: If this appliance is supplied from an

extension cord or portable electrical outlet device, the

extension cord set or electrical portable outlet device

must be positioned so that it is not subject to

splashing or contact with moisture.

￿ The power supply cable must only be replaced by

authorised technicians.

alternatively, rest it on the side of a washbasin or bathtub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater.

￿We advise against the use of hose extensions; if it is absolutely necessary, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity socket, make sure that:

•the socket is earthed and complies with all applicable laws;

•the socket is able to withstand the maximum power load of the appliance as indicated in the Technical data table (see opposite);

•the power supply voltage falls within the values indicated in the Technical data table (see opposite);

•the socket is compatible with the plug of the washer-dryer. If this is not the case, replace the socket or the plug.

￿The washer-dryer must not be installed outdoors, even in covered areas. It is extremely dangerous to leave the appliance exposed to rain, storms and other weather conditions.

￿When the washer-dryer has been installed, the electricity socket must be within easy reach.

￿ If the supply cord is damaged, it must be replaced

by the manufacturer, its service agent or similarly

qualified persons in order to avoid a hazard.

Warning! The company shall not be held responsible in the event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, using the wash cycle 1.

Technical data

Model	ARMF 125
	width 59,5 cm
Dimensions	height 85 cm
	depth 53,5 cm
	from 1 to 7,5 kg for the wash
Capacity	programme;
	from 1 to 4,5 kg for the drying
	programme
Electrical	please refer to the technical data plate
connections	fixed to the machine
Water	maximum pressure 1 MPa (10 bar)
	minimum pressure 0.05 MPa (0.5 bar)
connections
	drum capacity 52 litres
Spin speed	up to 1200 rotations per minute
Energy rated	Wash: programme 1; temperature 60°C;
programmes	using a load of 7,5 kg.
according to	Drying: cotton cycle performed with a
AS/NZS	4,5 kg load, by selecting the
2040.2	dryness level.

This appliance conforms to the following EC Directives:

-89/336/EEC dated 03/05/89 (Electromagnetic Compatibility) and subsequent modifications

-2002/96/EC

-2006/95/EC (Low Voltage)

3