If the inlet hose is not long enough, contact a specialised shop or an authorised technician.
Never use
Connecting the drain hose
The machine must not be installed outdoors, even in
covered areas. It is extremely dangerous to leave the | EN |
| |
appliance exposed to rain, storms and other weather |
|
conditions. |
|
The mains socket must remain within easy reach after |
the washing machine has been installed. |
Do not use extension cords or multiple sockets. |
65 - 100 cm |
Connect the drain hose to drain duct piping or a wall drain located between 65 and 100 cm above the floor, making sure it is not bent at all.
The cable should not be bent or compressed. |
The power supply cable and plug must only be |
replaced by authorised technicians. |
Warning! The company shall not be held responsible in the event that these regulations are not respected.
Alternatively, rest the drain hose on the side of a washbasin or bathtub, fastening the duct supplied to the tap (see figure).
The free end of the hose should not be underwater.
We advise against the use of hose extensions; if it is absolutely necessary, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity socket, make sure that:
• the socket is earthed and complies with all applicable |
laws; |
Technical data
Model | AQM8D 49 U H |
| |||
|
|
|
|
| |
| width 59,5 cm |
| |||
Dimensions | height 105 cm |
| |||
| depth 64,5 cm |
| |||
|
|
|
| ||
Capacity | from 1to 8 kg for wash programme | ||||
from 1 to 6 kg for the drying programme | |||||
| |||||
|
|
|
| ||
Electrical | please refer to the technical data | ||||
connections | plate fixed to the machine | ||||
|
|
|
| ||
| maximum pressure 1 MPa (10 bar) | ||||
Water connections | minimum pressure 0.05 MPa (0.5 bar) | ||||
| drum capacity 62 litres |
| |||
|
|
|
| ||
Spin speed | up to 1400 rotations per minute | ||||
|
|
|
|
| |
| Wash: programme |
|
| ; temperature | |
|
| ||||
|
|
|
• the socket is able to withstand the maximum power |
Energy rated
60°C; using a load of 8 kg.
load of the appliance as indicated in the Technical |
programmes
Drying: first drying cycle performed
according to
with a 2 kg load, by selecting the
regulation
drying level "IRON";
| data table (see opposite); |
• | the power supply voltage falls within the values |
| indicated in the Technical data table (see opposite); |
• | the socket is compatible with the plug of the |
| appliance. If this is not the case, have the socket or |
| the plug replaced. |
EN 50229
Second drying cycle performed with a 6 kg load, selecting the maximum drying level "EXTRA".
This appliance conforms to the following EC Directives:
- 89/336/EEC dated 03/05/89 (Electromagnetic Compatibility) and subsequent modifications
- 2006/95/EC (Low Voltage) - 2002/96/EC
3