Description of the machine, Touch Control Panel

Description of the machine

EN	PORTHOLE	CONTROL
	DOOR	CONTROL
	DOOR

PANEL

PORTHOLE DOOR HANDLE

CHEST

ADJUSTABLE FEET

PORTHOLE DOOR

		1. pre-wash compartment:
	3	use powder detergent.
	1	Before pouring in the
	1	detergent, make sure that
		detergent, make sure that
	2	extra compartment 3 has
		been removed.
		2. main wash compartment:
		use powder or liquid
		detergent. If using the latter
		type of detergent, we

recommend it is poured into the drawer immediately before you start the washer-dryer.

3.extra compartment: Bleach

The use of extra compartment 3 excludes the pre- wash function.

washing additives compartment: for fabric softener or liquid additives. We recommend that the maximum level indicated by the grille is not exceeded, and that concentrated fabric softeners are diluted.

CHEST

Always use the handle to open the porthole door (see figure).

Used to hold the soiled laundry. To open it, pull it outwards (see figure).

TOUCH CONTROL PANEL

To adjust the settings, gently press the icon inside the sensitive (touch control) area as illustrated in the figure.

Standby mode

This washer-dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after a few minutes if no activity is detected. Press the ON-OFF button briefly and wait for the machine to start up again.

CHANGE LANGUAGE

DETERGENT DISPENSER DRAWER

The detergent dispenser drawer is located inside the machine and can be accessed by opening the door. For more information on detergent measures, please refer to the chapter entitled “Detergents and

laundry”. Note: stick the label

showing the wash cycle descriptions and options on

the front of the detergent dispenser drawer. You will find the sticker in the pack containing this manual.

The first time the machine is switched on, the first language will flash on the display. The " ", "OK" and "V" symbols will appear on the display, in line with the 3 buttons on the right- hand side. The languages change automatically every 3"; alternatively, they can be changed by pressing the buttons next to the " " and "V" symbols. Use the "OK" button to confirm the language, which will be set after 2". If no buttons are pressed, the automatic language change will begin again after 30".

The language may only be changed while the machine is switched off.

Press and hold the temperature +spin +delayed start buttons for 5''; a short beep sounds and the set language flashes on the display. Press the buttons next to the " " and "V" symbols to change the language. Use the button next to the "OK" symbol to confirm the language, which will be set after 2". If no buttons are pressed, the language set previously will be displayed after 30". Switch on the machine.