AEG 16950A3 user manual No water is visible in the drum

	What to do if…
32
	Problem			Possible cause/Solution
			The electronic unbalance detection device has
			cut in because the laundry is not evenly distrib-
			uted in the drum. The laundry is redistributed
			by reverse rotation of the drum. This may hap-
	Spinning starts late or the machine does not		pen several times before the unbalance disap-
			pears and normal spinning can resume. If, after
	spin:		some minutes, the laundry is still not evenly
			distributed in the drum, the machine will not
			spin.
			• The laundry load is perhaps to little, add
				more items, redistribute the load manually
				and then select the spinning programme.
			The machine is fitted with a type of motor
			which makes an unusual noise compared with
	The machine makes an unusual noise:		other traditional motors. This new motor en-
			sures a softer start and more even distribution
			of the laundry in the drum when spinning, as
			well as increased stability of the machine.
	No water is visible in the drum:		Machines based on modern technology operate
			very economically using very little water with-
			out affecting performance.
			Anti-flooding system has activated.
	The display shows the alarm code	:	•	Disconnect the appliance, close the water tap
				and contact the Service Force Centre
	The laundry is full of different colored fluff:		The fabrics washed in the previous cycle re-
			leased fluff of a different color (refer to “Fluff in
			the garments” in chapter “Use - Washing &
			Drying”).
			•	The drying phase helps to eliminate some
				fluff.
			•	Clean the clothes with a fluff remover.
			In case of an excessive amount of fluff in the
			drum repeat the following procedure twice:
			•	Thoroughly clean the empty drum, the gasket
				and the door with a wet rag.
			•	Perform a rinse cycle.
			•	Put a wool or piled fabric rag inside the
				drum.
			•	Perform a drying cycle of 10 minutes.
			•	Remove the old wool cloth.
			Now you can wash other garments.