Prima Donna Designs LPR 710 manual Water inlet filter

Page 17

Unscrew and remove the filter.

Clean carefully under a fast running tap.

P0039

P0040

Warning

When the appliance is in use and depending on the programme selected there can be hot water in the filter. Never remove the filter during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the filter, ensure it is securely retightened so as to stop leaks and young children being able to remove it.

The water inlet filter

If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.

It is therefore a good idea to clean it from time to time.

Turn off the water tap. Unscrew the water inlet hose. Clean the filter using a hard bristle brush.

Tighten up the inlet hose.

P1090

The dangers of freezing

If the machine is exposed to temperatures below 0°C, certain precautions should be taken.

Turn off the water tap.

Unscrew the inlet hose.

Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hose in a bowl. Run the draining programme.

Disconnect the appliance.

Screw the inlet hose and reposition the drain hose.

When you intend to start the machine up again, make sure that the room temperature is above 0°C.

17

Image 17
Contents Washing Machine Child Safety InstallationUseContents Interest Environment Your New Washing MachineEcological hints Detergent dispenser drawer Description of the ApplianceControl Panel Operating Sequence At the end of the programme Start the machineWashing 2 KG of Mixed Fabrics AT 50C At the end of the programme 1000g = 1 kg Washing HintsWhich form? Which detergent?Important Notes Wash Care SymbolsOptions Washing ProgrammesType of laundry Load Washing symbol Type of laundryMaintenance and Cleaning Water inlet filter Something Not Working Symptom Possible causes Service & Spare Parts0870 5 Customer CareStandard guarantee conditions Guarantee ConditionsEuropean guarantee This guarantee does not coverTechnical Specifications Installation InstructionsUnpacking Installation on a Suspended FloorAppliance must be connected to a cold water supply Water inletWater drainage Interest of the environment LevellingSpecial conditions Permanent connection Electrical connectionBuilding-in Preparation and assembly of the doorFront view