Maytag LAT8804 Wash ER, Indicator Lights Lights will vary, Start the Washer, According to model

Start the Washer

Pull out the cycle control knob to start the washer. You will hear water entering the wash tub.

The washer will fill to the selected water level with the

selected wash water temperature. After filling, it will agitate for the selected number of minutes,

The washer will pause briefly throughout each cycle. These pauses are normal.

This washer is designed so that it will not agitate or spin when the lid is open. It will, however, fill with the

lid open so water is available for pretreating stains or diluting fabric softener,

Should the lid be opened during a cycle, the washer will stop; when the lid is dosed and the control knob is pulled out, the washer will resume its cycle at the point it was interrupted,

Indicator Lights (Lights will vary

according to model)

The ON light stays lit throughout the entire cycle indi- eating the washer is operating. The SOAK light is on during the soak cycle.

MAINTAININGTHE

WASH ER

*Turn off the water faucets after finishing the day's washing. This will shut off the water supply' to the

washer and prevent the unlikely possibili_ of dam- age from escaping water.

°Clean the control panel with a soft damp cloth and glass cleaner. Do not use any abrasive powders or

cleaning pads.

°Clean the cabinet with soap and water followed with an appliance wax, if desired.

• The SELF-CLEAN LINT FILTER is located under the agitator on the bottom of the washtub. The lint filter in this washer cleans itself. During

the wash and rinse portion of the cycle, lint is col- lected on the filter. The filter is then flushed anto-

matically during the spin and drain.

STORINGTHE WASHER

W:ashers can be damaged if water is not removed from

hoses and internal components before storage. Prepare the washer for storage as follows:

•Select NORMAL cycle on Regular Fabrics and add one cup of bleach or white vinegar to a full load of water without clothes. Run the washer through a complete cycle.

•Turn the water faucets off and disconnect the inlet hoses.

•Advance the cycle control knob to the spin of Regular Fabrics and lower drain hose to drain any water that may be in the drain hose.

•Disconnect the washer from the electrical supply

and leave the washer lid open to let air circulate inside the tub.

PAGE6