Zanussi WJS 1465 W, WJS 1665 W, WJS 1265 W manual SKIP/RESET button, Selecting a special programme

When you PAUSE the cycle, the DOOR LOCKED light goes out, and it becomes possible to open the door, provided

•the machine is not in the heating or drying phase;

•the level of the water is not high;

•the drum is not turning.

Important! You must set the washing machine to PAUSE before you make any change in the programme in progress.

•Draining of water and spinning after the execution of programmes with the RINSE HOLD option.

11 SKIP/RESET button

This button performs two functions:

-Clears the memory

-Selects special programmes

At the end of every programme the RESET button must be pressed once or repeatedly to clear the programme memory. This will be confirmed by three dashes, flashing in the display.

If the previous programme is not cleared, the display will show a “0” flashing and an audible signal will sound, when you switch the machine on.

Selecting a special programme:

A wash programme must be selected in the normal way. (START button not pressed)

To select rinse & spin, press the SKIP button once, the wash LED goes out.

To select spin only, press the SKIP button twice. The wash & rinse LED,s go out.

To select Drain press the SKIP button three times, the wash - rinse - spin LED,s go out.

A normal wash cycle consists of the following phases, Wash - Rinses - Spin and is confirmed by the illumination of the corresponding LED,s.

PREWASH

WASH

RINSES

SPIN

DRAIN

DRYING

If you wish to cancel or advance the running programme to the required phase, PAUSE the cycle and then press the SKIP button as previously described.