Zanussi WJD 1667 W manual Electrical connection, Permanent connection, Blue- Neutral Brown- Live

Page 29

Electrical connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s rating plate. The rating plate is located at the top of the rim of the open door.

 

Mod

 

Prod. No

P0042 BD

Ser. No

 

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

- Earth

Blue- Neutral

Brown- Live

GREEN & YELLOW

E

The wire coloured blue must be connected to the terminal marked «N» or coloured black.

The wire coloured brown must be connected to the terminal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

WARNING:

A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely.

Should the appliance power supply cable need to be replaced, this should be carried out by our Service Force Centre.

Note

When the appliance is installed the power supply cable must be accessible.

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

N

13 A

L

BROWN

BLUE

P1041

CORD CLAMP

 

The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow.

29

Image 29
Contents WASHER-DRYER Use InstallationChild Safety Contents Interest Environment Your New Washer-DryerEcological hints Description of the Appliance Child safety featureDoor locked light Detergent dispenser drawerControl Panel Auto DRY button Options buttonDrying Time button DisplaySelected drying time in minutes or hours and minutes Duration of washing programme in hoursMinutes, after you have selected a programme START/PAUSE button SKIP/RESET buttonThis button has three functions Selecting a special programmeProgramme phase indicator lights Delay Start buttonOperating Sequence Select the Delay Start Select the temperatureSelect the desired options Start the programmeEnd of programme How to cancel a programme during its cycleRemove the laundry Press the START/PAUSE button to start the programme1000g = 1 kg Washing and Drying HintsWhich form? Which detergent?Important Notes Wash Care SymbolsWashing programmes Degree of drying Type of fabric Max. load Spin speed Drying ProgrammesMaintenance and Cleaning Water inlet filter Clean carefully under a fast running tapSomething Not Working 0870 5 Symptom Possible causesStandard guarantee conditions Guarantee ConditionsEuropean guarantee Customer Care DepartmentDrying Installation InstructionsTechnical Specifications Install the machine on a flat hard floor Installation on a Suspended FloorUnpacking PositioningWater drainage Water inletInterest of the environment LevellingSpecial conditions Blue- Neutral Brown- Live Electrical connectionPermanent connection Electrolux plc From the Electrolux Group. The world’s No choice