Zanussi IZ10 manual Detergents and additives, Quantity of detergent to be used, Degrees, Level

Page 15

Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly.

Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste.

(*) do not use acetone on artificial silk.

Detergents and additives

Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature.

The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc.), the colour, washing temperature and degree of soiling.

All commonly available washing machine detergents may be used in this appliance:

powder detergents for all types of fabric,

powder detergents for delicate fabrics (60°C max) and woollens,

liquid detergents, preferably for low temperature wash programmes (60°C max) for all types of fabric, or special for woollens only.

The detergent and any additives must be placed in the appropriate compartments of the dispenser drawer before starting the wash programme.

If using concentrated powder or liquid detergents, a programme without prewash must be selected.

The washing machine incorporates a recirculation system which allows an optimal use of the concentrated detergent.

Pour liquid detergent into the dispenser drawer

compartment marked just before starting the programme.

Any fabric softener or starching additives must be poured into the compartment marked before starting the wash programme.

Follow the product manufacturer’s recommendations on quantities to use and do not exceed the «MAX» mark in the detergent dispenser drawer.

Quantity of detergent to be used

The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used.

Water hardness is classified in so-called “degrees” of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority.

Follow the product manufacturers’ instructions on quantities to use.

Use less detergent if:

you are washing a small load,

the laundry is lightly soiled,

large amounts of foam form during washing.

Degrees of water hardness

 

 

Degrees

Level

Characteristic

 

 

German

French

 

 

 

 

°dH

°T.H.

 

 

 

 

1

soft

0- 7

0-15

 

 

2

medium

8-14

16-25

 

 

3

hard

15-21

26-37

 

 

4

very hard

more than

more than

21

37

 

 

 

 

 

 

ENGLISH

15

Image 15
Contents Automatická Pračka Automatická Práčka Dear customer Contents General safety Packaging materials Child safetyDisposal Tips for environmental protectionWater Pressure Technical specificationsWater inlet InstallationUnpacking PositioningWater drainage Electrical connectionConnect the machine to an earthed socket Detergent dispenser drawer Your new washing machineDescription of the appliance Door locked pilot lightUse Drain only Options buttonTime Save button DisplaySTART/PAUSE button SKIP/RESET buttonExample Delay buttonProgramme phase indicator lights If the machine is switched offBefore loading the laundry TemperaturesLaundry weights Sorting the laundryDegrees Detergents and additivesQuantity of detergent to be used Do not use acetone on artificial silkIroning Dry cleaningEnergetic wash Delicate wash BleachingMeasure out the additive Switch the machine onPlace the laundry in the drum Measure out the detergentSelect the desired options Select the temperatureSelect the Delay Time Select the spin speed or the Rinse Hold optionHow to change a programme during its cycle How to cancel a programme during its cycleEnd of programme Washing programmes Drain filter MaintenanceDoor seal BodyworkEmergency emptying out Water inlet filterSomething not working? Water is not visible Door will not openSpinning starts late or Laundry is not spun enough