Zanussi WIJ1075 manual Positioning, Water inlet, Water drainage

Page 7

Positioning

Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

P1051

Water inlet

Connect the water inlet hose to a tap with a 3/4" thread.

The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks.

The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.

P1088

P0021

ENGLISH

 

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying.

This could be done by tying it to the tap with a piece of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground.

Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm.

The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose.

The drain hose must not be kinked. Run it along the floor; only the part near the drainage point must be raised.

P0022

P0023

75

Image 7
Contents WIJ1075 Packaging recycling Hints on how to save energyYour NEW WASHER-DRYER Environment protectionContents General warnings Service/repairDescription of the Appliance Technical SpecificationsDetergent dispenser drawer and programme card Transit devices InstallationWater inlet PositioningWater drainage Electrical connection Building-inCounter-magnet DoorHinges Mounting the doorUSE Automatic washing and drying NON- Stop programme Programme selectionWashing only Drying onlyWashing and drying hints Degrees of water hardness Detergents and additivesQuantity of detergent to be used DryingOperating sequence Select the programme and start the machine Select the drying timeAt the end of the programme 30-60 Energetic programmes for cotton and linenWashing 60-9040-60 Dry cleaning International wash code symbolsBodywork MaintenanceDrain filter Water inlet filter Frost precautionsEmergency emptying out Something not WORKING? Problem Possible causeMachine makes an unusual Door will not openSpinning starts late or Machine does not spinFrom the Electrolux Group. The world’s No choice