Zanussi Washer/Dryer user manual Ones

In the stands drawer you will find an envelope with all the necessary material for a correct assembly. Have ready a Phillips screwdriver to fit rear brackets to the stand and an Torx screwdriver to fit rear brackets to the machines back.

The pack includes:

•2 grey short rubber feet to be used for the following tumble dryer models:

•2 white long rubber feet to be used for the following tumble dryer models:

•6 rear metal brackets (4 for washing machine and 2 for tumble dryer) ;

•6 self-tapping screws (4.2 x 13 mm);

•1 key to adjust the stands feet.

Important! Before starting the installation, adjust the stand's feet in order to achieve a perfectly stable hori- zontal position.

fig. 2

Proceed as follows (fig. 2):

•loosen the nuts using the key supplied with the stand;

•adjust the feet to allow for an uneven floor;

•tighten up all check nuts.

fig. 3	fig. 4
Lay the machine on its left	Tighten the back feet (fig.
side, making sure you do	4).
not damage it. Remove the
front feet (fig. 3) and re-
place them with the rubber
ones.

Warning! If you install the stand under an energy saver model Class A, you must not use the tumble dryer immediately. Please wait 8 hours at least. For more

detailed information, read the appliance user manual carefully.

SX

fig. 5 fig. 6

5