Zanussi WD 15 manual Unpacking, Positioning, Install the machine on a flat hard floor

Page 29

Unpacking

All transit bolts and packing must be removed before using the appliance.

You are advised to keep all the packaging for re-use in case the machine is to be transported again.

Using a spanner unscrew and remove the rear right bolt. Lay the machine gently on its back, making sure that the hoses are not squashed.

Remove the polystyrene block from the bottom of the machine.

Carefully slide out the right polythene bag (1).

Repeat the operation for the left polythene bag (2).

Remove the polystyrene base.

Set the machine upright and remove the two remaining bolts from the back.

Pull out the three plastic spacers from the holes into which the bolts were fitted.

Plug the open holes with the plugs which you will find in the plastic bag containing the instruction booklet.

P0255

P0234

P0256

2	1
P0233

P0020

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.

Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

Your new machine has been designed to be permanently plumbed in to your home’s water supply and drainage system. However, if this is not possible, it may be connected to a suitable existing tap with the drain hose discharging into a sink.

29

Image 29

Contents WASHER-DRYER Use InstallationChild Safety Contents Your New Washer-Dryer Delicate wash action suitable for garments with Wash symbolEcological hints Interest EnvironmentDescription of the Appliance Door locked indicator lightDetergent dispenser drawer Prewash Main wash Fabric softenerFabrics button ON/OFF-Cancel buttonControl Panel Spin Speed button Temperature buttonAdditional options ProgrammeTime to Finish display Auto DRY buttonDrying Time button START/PAUSE button Delay Start buttonOperating pilot lights Altering a programme which is runningProgramme selection Selection using the Memory buttonsWashing Selection by means of the different push-buttonsOperating Sequence Switch the machine onLoad the laundry Measure out the detergentSelect spin speed or Rinse Hold option Select the temperatureStart the programme Store the programmeAt the end of the programme Automatic washing and drying DryingWashing and subsequent drying DryingSelect drying Load the laundry Switch the machine onDrying only 1000g = 1 kg Washing and Drying HintsLaundry and placed in the tumble dryer Which detergent?Which form? Duration of the drying cycle Preparing the drying cycleAdditional drying Fibre residueImportant Notes Wash Care SymbolsWashing Programmes Detergent quantities Special ProgrammesProgramme Type of laundry Additional functions Max. load Rinses Used for rinsing handDrying time in minutes to be Drying ProgrammesDegree of drying Type of laundry 1500 rpmMaintenance and Cleaning It is therefore a good idea to clean it from time to time Cleaning the filterWater drain filter Water inlet filterSomething Not Working Symptom Possible causes Service & Spare Parts0870 5 Customer CareEuropean guarantee Standard guarantee conditionsThis guarantee does not cover ExclusionsDrying Installation InstructionsTechnical Specifications Positioning Install the machine on a flat hard floorUnpacking Water drainage Water inletInterest of the environment LevellingSpecial conditions Blue- Neutral Brown- Live Electrical connectionPermanent connection