JVC MX-J585V Recording, Press REC START/STOP s, To clean the heads, capstants and pinch rollers

English

Recording

IMPORTANT:

•It may be unlawful to record or play back copyrighted material without the consent of the copyright owner.

•The recording level is automatically set correctly, so it is not affected by the VOLUME control. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.

•While recording, you can hear sound modes and/or the Signal Adaptive Bass effect through the speaker or headphones. However, the sound is recorded without these effect (see page 8).

•If recording you have made have excesssive noise or static, the unit may be too close to a TV. Increase the distance between the TV and the unit.

•You can use type I and II tapes for recording.

To protect your recording Cassettes have two small tabs on

the back to protect unexpected erasure or re-recording.

To protect your recording, remove these tabs.

To re-record on a protected tape, cover the holes with adhesive tape. When using type II tape, be careful not to cover the holes used to detect the tape type.

To keep the best recording and playback sound quality

If the heads, capstant, and pinch rollers of the cassette decks become dirty, the following will occur:

•Impaired sound quality

•Discontinuous sound

•Fading

•Incomplete erasure

•Difficulty in recording

To clean the heads, capstants and pinch rollers

Use a cotton swab moistened with alcohol.

Pinch rollers

Capstans

Heads

To demagnetize the heads

Turn off the unit, and use a head demagnetizer (available at electronics and record shops).

Recording Tapes on Deck B

1 Press EJECT 0o for the deck B.

2 Put in a recordable cassette, with the exposed part of the tape down.

3 Close the cassette holder gently.

4 Check the tape direction of deck B.

•If the tape direction is not correct, press TAPE 2 3 7, - twice then 7 z, _ to change the tape direction.

5 Start playing the source — FM, AM*, CD player, deck A or auxiliary equipment connected to AUX jacks.

•When the source is CD, you can also use CD Direct Recording (see page 20) and Auto Edit Recording (see page 21).

•When the source is deck A, you can also use the dubbing method. (See “Dubbing Tapes” on page 20.)

* See “To record an AM station — Beat Cut” on page 20.

6 Start recording. On the unit:

Press REC START/STOP s.		REC
		START/STOP
The	indicator lights up on the display and
recording starts.
On the remote control:		REC PAUSE
1) Press REC PAUSE 8.
The	indicator starts flashing on the display.
2) Press TAPE 2 3 - .
The	indicator stops flashing and remains
lit, and recording starts.

To stop during recording, press REC START/STOP s again (or 7 _ on the remote control).

To stop recording temporarily (except when the REC PAUSE playback source is deck A), press REC PAUSE 8 on the

remote control.

To resume recording, press TAPE 2 3 7, -.

To remove the cassette, press EJECT 0 o for deck B.

19 Continued