Zanussi TCS 603 LT manual Installation, Positioning, Stacking kit, Connecting a drain hose

Page 7

Installation

Positioning

It is recommended that, for your convenience, the machine is positioned close to your washing machine.

The tumble dryer must be installed in a clean place, where dirt does not build up.

Air must be able to circulate freely all round the appliance. Do not obstruct the front ventilation grille or the air intake grilles at the back of the machine.

To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface.

Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is.

The feet must never be removed.

Do not restrict the floor clearance through deep- pile carpets, strips of wood or similar. This might cause heat build-up which would interfere with the operation of the appliance.

Important

The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance must therefore not be installed on floors which are not resistant to high temperatures.

Stacking kit

A special stacking kit is available through your dealer, to enable the mounting of the dryer on top of your washing machine.

P1044

Connecting a drain hose

If there is a sink or drain near the appliance, the condensed water can be discharged directly through a hose that is available on the market.

In order to connect the hose to the appliance proceed as follows:

Remove the clamp (A);

Pull out the plug (B);

Insert the drain hose (C);

Fasten the hose (C) to the appliance using the clamp (A).

ENGLISH

When operating the tumble dryer, the room temperature must not exceed 35°C, as it may affect the performance of the appliance.

Electrical connection

This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply.

Check that your domestic electrical installation can take the maximum load required (2.2 kW), also

 

A

 

B

 

A

B

C

P1043

 

C

P1046

taking into account any other appliances in use.

Connect the machine to an earthed socket, in accordance with current wiring regulations.

The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution.

If the appliance is stacked on the washing machine, the condensed water can be discharged through the hose as shown in figure, but take into account that the hose must be pointed downwards.

7

Image 7
Contents SUfiILWNAÅ MAfiINA Transport damages Dear customerTechnical specifications ContentsUse Important safety informationInstallation General safetyPackaging materials Child safetyDisposal Tips for environmental protectionDescription of the appliance Your new tumble dryerStacking kit InstallationConnecting a drain hose PositioningUse Synthetics Cotton and LinenSize of load After drying Operating sequenceUseful hints Cleaning the condenser unit Maintenance and CleaningExternal cleaning Cleaning the filterDryer does not dry properly Problem Possible causeSomething not working? Dryer does not work