125986546.qxp
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes to indicate that the machine is not working.
Once the problem has been eliminated, press the Start/Pause button to restart the programme. If after all checks, the problem persists, contact your local Service Centre.
Malfunction | Possible cause | Solution |
| ● Mains plug is not plugged in or fuse | ● Plug in at mains socket. Check fuse |
| is not working correctly. | in fuse box (domestic installation). |
Dryer does not work. | ● Loading door is open. | ● Close loading door. |
| ● Have you pressed the START/ | ● Press the START/PAUSE button |
| PAUSE button? | again. |
|
|
|
| ● Wrong programme selected. | ● Select a different programme the next |
|
| time you dry. |
| ● Lint filter clogged. | ● Clean lint filter. |
| ● Heat exchanger clogged with lint. | ● Clean heat exchanger. |
Drying results | ● Incorrect volume of laundry. | ● Observe recommended loading |
| volumes. | |
unsatisfactory. |
| |
|
| |
| ● Ventilation slots in base area covered up. | ● Uncover ventilation slots in base area. |
| ●Residue on inside surface of | ● Clean inside surface of drum and |
| drum or drum ribs. | drum ribs |
|
| |
| ●Conductance of water at installation | ● |
| degree of drying. | |
| site differs from | |
| standard setting of machine. |
|
|
|
|
Loading door does not | ● Fine strainer not in place and/or large | ● Install fine strainer and/or snap large |
close. | mesh filter not locked in place. | mesh filter into place. |
|
|
|
16