125986546.qxp
Malfunction | Possible cause | Solution | |
When pressing a button, | ● Washing protection. |
| |
the corresponding | ● Turn the programme knob to OFF. Set | ||
After the start of the programme, | |||
button flashes several | the programme again | ||
the option can no longer be set. | |||
times. |
| ||
|
| ||
Drying cycle ends | ● Not enough washing loaded | ● Select time programme or | |
shortly after programme starts. | |||
END | or washing loaded is too | higher drying level (e.g. EXTRA DRY | |
dry for selected programme. | instead of CUPBOARD). | ||
light illuminated. | |||
|
| ||
Programme inactive, |
| ● Empty condensate tank, then start | |
Condenser | ● Condensate tank is full. | programme with START/PAUSE | |
light illuminated. |
| button. | |
|
|
| |
| ● Lint filter clogged. | ● Clean lint filter | |
| ● Clean heat exchanger. | ||
Drying cycle lasts an | ● Heat exchanger clogged with lint. | ||
| |||
unusually long time. |
| ||
|
| ||
Note: | ● DELICATE button pressed and | ● DELICATE is only suitable for use | |
After around 5 hours | |||
load volume too big. | with loads of up to 3 kg! | ||
the drying cycle ends | |||
|
| ||
automatically (see | ● Load volume too big. | ● Reduce load volume. | |
„Drying cycle complete“) | |||
|
| ||
| ● Laundry insufficiently predrained. | ● Laundry must be adequately | |
|
| ||
|
|
|
If you are unable to identify or solve the problem, contact your local Service Centre. Before telephoning, make a note of the model, serial number and purchase date of your machine: the Service Centre will require this information.
1206 |
Important:
If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
17