Installation

125987350.qxp 2007-01-09 15:02 Page 25

installation electrolux 25

Slide out the polythene bag with the polystyrene stuffing before using the

appliance. Pull off adhesive strips from inside machine on top of drum.

It is recommended that, for your convenience, the machine is positioned close to your washing machine.

The tumble dryer must be installed in a clean place, where dirt does not build up.

Air must be able to circulate freely all round the appliance. Do not obstruct the front ventilation grille or the air intake grilles at the back of the machine.

To keep vibration and noise to a

minimum when the dryer is in use, it should be placed on a firm, level surface.

Once in its permanent operating position,

check that the dryer is absolutely level GB with the aid of a spirit level. If it is not,

raise or lower the feet until it is.

The feet must never be removed. Do not restrict the floor clearance through deeppile carpets, strips of wood or

similar. This might cause heat build-up which would interfere with the operation of the appliance.

The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance must therefore not be installed on floors which are not resistant to high temperatures.

When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance.

A special stacking kit is available through your dealer, to enable the mounting of the dyer on top of a front loading washing machine with cover’s depth between 48 and 60 cm.

Read carefully the instructions supplied with the kit.