Operating Sequence
Before using your tumble dryer for the first time, we recommend you to place a few damp cloths inside the appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1.Connect the appliance.
2.Open the door (see picture).
stop automatically at the end of the
The END, CLEAN FILTERS and FULL TANK lights remain lit and the buzzer sounds for 2 minutes.
The light of the START/PAUSE button goes off and a flashing zero appears on the display.
10.Turn the programme selector dial to “RESET/ OFF”; all the lights go out. The appliance is switched off.
P1149 |
P1108 |
Remove the laundry.
If you open and then close the door before turning the programme selector dial to “RESET/OFF”, all the lights corresponding to the phases making up the performed programme come on and the display shows the duration of the programme.
3.Load the items one at a time, shaking them out loosely.
4.Close the door. Please check the laundry does not get caught between the door and filter.
5.Select the drying programme or time. The lights DRYING, COOLING and END come on. The light of the START/PAUSE button flashes and the display shows the duration of the programme.
6.If required, press the LOW TEMPERATURE button and/or the NO BUZZER button or the QUICK DRY button.
7.Select the DELAY START if required. The selected delay appears on the display for 2 seconds, then the duration of the selected programme is displayed.
8.Press the START/PAUSE button: the corresponding light stops flashing and drying starts. Only the DRYING light stays lit. If you have selected the DELAY START, the machine begins its countdown.
The drum turns alternately in both directions during drying.
All drying programmes end with a 10 minute cooling phase (light COOLING is on).
You may remove the laundry after this phase.
The END, CLEAN FILTERS and FULL TANK lights illuminate. The display shows a static zero and the buzzer sounds to indicate the end of the cycle.
9.If the laundry is not removed at the end of the cycle, the dryer performs an
If you do not remove the laundry, the dryer will
After each use
•Clean the filters (see page 11).
•Empty the water reservoir (see page 12).
Important!
If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position “Cooling” and wait until the end of this phase before removing the laundry. This will avoid a
Modifying the programme
To change a programme which is running, first cancel it by turning the programme selector dial to “RESET/ OFF”. Select the new programme and press the START/PAUSE Button.
9