The Control Panel
78910
ELECTRONIC SENSOR
TDE 4234 W
|
| COTTON |
|
|
| SYNTHETICS |
| TIMED | LOW | BUZZER | START | ||
|
|
|
|
|
|
|
|
|
| PROGRAMME | TEMP. | OFF |
|
EXTRA | READY | STORE | SLIGHTLY | IRON | WRING | EXTRA | STORE | SLIGHTLY | BABY | DRY |
|
|
|
DRY | TO WEAR | DRY | DAMP | DRY | DRY | DRY | DRY | DAMP | DRY | FRESH |
|
|
|
A | B | C | D | E | F | G | H | J | K | L |
|
|
| 6 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
| IMPORTANT: PLEASE READ THE INSTRUCTION BOOK BEFORE USING THIS APPLIANCE | A U T O R E V E R S E | XTRACAPACITY |
| SELECTOR | ||||||||
1 | 2 | 3 | 4 | 5 | 6 | 11 |
1Programme Chart
This will help you to select the correct programme for drying.
This button must also be pressed after a power cut. In both cases light 
or 
(depending on the phase in progress) flashes to remind you that the start button needs to be pressed again.
2 Mains-On Light
It comes on when the appliance is switched on (ON- OFF button pressed down) and goes out when this button is released.
3 ON-OFF Button 
This button is used to switch the dryer on. At the end of the programme, release this button by pressing it again to switch the dryer off.
4 Low Temperature Button 
Pressing this button allows drying to be performed at a lower temperature, for delicate items.
The corresponding pilot light comes on.
5 Buzzer OFF Button 
Press this button when selecting the programme if you wish to switch the buzzer off during the anti- creasing phase.
The corresponding light illuminates.
6 Start Button 
Press this button for about 2 seconds to start the dryer after having selected the drying programme.
If the door is opened while the programme is running, this button must be pressed again after closing the door in order to
7 “Drying” Light 
This light indicates that the machine is performing the drying phase.
8 “Cooling” Light 
This light indicates that the appliance is in the cooling phase. At the end of drying, there is a 10 minute cooling phase to cool the laundry.
If light 
or 
is flashing, this means that the Start Button needs to be pressed again for the programme to resume.
9 “End of Programme” Light 
This light flashes at the end of the cooling phase and during the
10 “Anti-creasing” Light 
This light flashes alternately with the light 
at the end of the drying phase (after cooling) and during the
If only light 
flashes, this means that the anti- creasing phase has finished.
11 Programme/Time Selector Dial
It allows you to select electronically controlled or time controlled drying.
Turn the dial to the required programme or time.
6