Maytag LAT9904 operating instructions Operating Instructions, Pre-Programmed Cycles

Page 5

OPERATING INSTRUCTIONS

Using the Washer at a Glance

Operating the washer can be as simple as touching one cycle pad. The pre-programmed wash cycles automati-

cally provide warm water washes, cold water rinses and extra large water levels,

However, cycles can also be changed to fit load varia- tions. They can even be programmed for customized

care of special wash loads.

After adding proper laundry additives and placing the load in the wash tub:

1.Press a wash cycle program pad. (When a pad is properly pressed, an audible tone will be heard and a red indicator will light.) A warm water wash and cold

rinse in a full tub of water is automatically provided, If these are appropriate for the load, there is no need

to make any other selections.

If a previous load has not been removed, the washer will not acknowledge the cycle selection. The word

"lid" will appear in the Monitor. To continue, the lid must be raised and lowered and the wash cycle re- selected.

Cycle selection can be changed while the washer is filling by pressing another cycle pad. After the fill is complete the cycIe cannot be changed,

If the pre-progranamed options are not appropriate for

the load:

2.Change the wash temperature by pressing the WASH TEMP ADJUST pad.

3.Change the load size by pressing the WATER LEVEL ADJUST pad.

4.Change the wash time by pressing the TIME

ADJUST pad - • to decrease time or • to increase time.

5.Select other desired options by pressing the appro- priate pads.

Please read the following detailed instructions on how to best use this washer.

Select Wash Cycle Program

Pre-Programmed Cycles

For REGULAR FABRIC loads, press the REGU- LAR FABRICS pad. After a slight pause, the washer will fill and automatically select an Extra Large Water Level, Warm Wash/Cold Rinse and 10 minutes of agi- tation. "Wash 10 Minutes" will appear in the Monitor. (To change these options see the following section.)

Use this cycle for everything washable except

permanent press, delieates and woolens.

For PERMANENT PRESS loads, press the PERM. PRESS pad. After a slight pause, the washer will f_ll and automatically select an Extra Large Water Level, Warm Wash/Cold Rinse and 8 minutes of agitation. "Wash 8 Minutes" will appear in the Monitor. (To change these options see the following section.) Use

this cycle for permanent press items and synthet-

ies (nylon, polyester, acrylic, ere.). This cycle auto- matically provides a cool down rinse to minimize wrin-

kling when hot or energy-saver hot wash temperatures are used.

For KNIT and DELICATE loads, press the KNITS/ DELICATES pad. After aslightpause, the washerwilI fill and automatically select an Extra Large Water

NOTE: If you experience problems selecting the correct water temperature, or cycle, or starting the washer, reler to page 9 for additional information before calling for service.

PAGE 4

Image 5
Contents Table of Contents Ance, follow basic precautions, including the following Important Personal Safety InstructionsMeasured amount of detergent to washtub before loading Using Laundry AdditivesDetergent With wa te r Loading the WasherFabric Softener Pre-Programmed Cycles Operating InstructionsCustomized Care Cycles Knits, sheer fabrics, lingerie and washable woolensSpecial Cycles Up to 30 minutes are sufficient for most loadsWater Level Water TemperatureSignal Level Select Options Cycle Descriptions Storing the Washer MaintainingMwi.9nw l, h QklmL ,J ,=tlmCheck these points if your washer Before YOU Call for ServiceTo Receive Warranty Service Automatic Washer Warranty