Maytag LAT9904 Before YOU Call for Service, Check these points if your washer

Page 10

BEFORE YOU CALL FOR SERVICE

Check these points if your washer...

 

WON'T

FILL

• Plug cord

into live electrical outlet.

 

 

• Check fuse or reset circuit breaker.

 

 

• Select wash cycle by touching appropriate program pad. If"lid" appears in the mon-

 

 

itor, raise mad lower lid and re-select wash cycle.

 

 

• Turn both

faucets on fully.

 

 

• Straighten

inlet hoses.

 

 

• Disconnect hoses and check hose filter screens. Clean screens, if plugged.

WON'T

AGITATE

• Check fuse or reset circuit breaker.

 

 

• Close lid, For your safety, washer will not agitate or spin unless the lid is dosed.

in monitor, raise and lower hd. If "lid remains displayed. Call for service.

The washer is equipped ruth a hd _tch failure detector. If the hd smtch appea s Hose filter screens plugged. Disconnect hose and clean screens.

WON'T SPIN OR DRAIN

STOPS

"Unbalanced" appears in monitor and signal sounds. Redistribute the load evenly and close the hd. Check for leveling. Be sure water level is acceptable for load size.

Check fuse or reset circuit breaker.

Select wash cycle by touching appropriate program pad.

Straighten hoses. Eliminate Milked hoses. If there is a drain restriction, call for service.

Close lid. For your safety, washer will not agitate or spin unless the lid is dosed.

Suds lock- caused by too much suds. Rewash without detergent. Use correct amount of a low-sudsing detergent.

The washer is equipped with a lid switch failure detector. If the "lid" appears in monitor, raise and lower the lid. If "lid" remains displayed, call for service.

• "Unbalanced" aPP ears in monitor and signal sounds ' Redistribute the load evenly and close the lid. Check for leveling. Be sure water level is acceptable for load size.

Plug cord into live electrical outlet. Check fuse or reset circuit breaker.

Select wash cycle by touching appropriate program pad.

Straighten hoses. Eliminate kinked hoses. If there is a drain restriction, call for service.

Close lid. For your safety, washer will not agitate or spin unless lid is dosed.

This may be a pause or soak period in the cycle. Wait several minutes and it may start.

Suds lock - caused by too much suds. Rewash without detergent. Use correct amount of low-sudsing detergent.

The washer is equipped with a lid switch failure detector. If "lid" appears in moni- tor, raise and lower lid. If "lid" remains displayed, call for service.

LEAKS

WATER

* Make sure

hose

connections

are tight_

 

 

 

Make

sure

end

of drain

hose

is correctly

inserted and secured to drain facility'.

 

 

Extended soaking - soak

for

30 minutes

or less.

IS NOISY

Make

sure

washer is level

and firm to the floor.

 

 

• Weak floors can cause vibration and walking.

FILLS

WITH TIlE WRONG

• Turn

both

faucets on fully.

 

 

TEMPERATURE WATER

• Make

sure

temperature

selection is correct.

Make sure hoses are connected to correct faucets and inlet connections. Be sure water supply is regulated correctly. Flush water line before f'rJlingwasher.

Be sure water supply is regulated correcdy.

Flush water line before idling washer.

Check the Water heater. It should be set to deliver a minimum 120°F (49°C) hot water at the tap. Also check water heater capacity and recovery rate.

Hose filter screens plugged. Disconnect hose and clean screens.

NOTE: For further information contact Maytag Customer Assistance:

U.S.

1-800-688-9900

 

Canada 1-800-688-2002

PAGE 9

Image 10
Contents Table of Contents Important Personal Safety Instructions Ance, follow basic precautions, including the followingDetergent Using Laundry AdditivesMeasured amount of detergent to washtub before loading Fabric Softener Loading the WasherWith wa te r Operating Instructions Pre-Programmed CyclesSpecial Cycles Knits, sheer fabrics, lingerie and washable woolensCustomized Care Cycles Up to 30 minutes are sufficient for most loadsSignal Level Water TemperatureWater Level Select Options Mwi.9nw l, h Storing the Washer MaintainingCycle Descriptions QklmL ,J ,=tlmBefore YOU Call for Service Check these points if your washerAutomatic Washer Warranty To Receive Warranty Service