Haier XQG50-S1216 Installation Maintenance, Adjusting the position of the washing machine

Installation

Maintenance

As shown in Fig.1, remove all the packing materials

(in cluding the foam base ). It is normal that there are some water drops on the plastic bag, the cushion and the porthole. It is because of the water testing before leaving the factory.

Fig.1

1. Remove the power plug, open the porthole	2. The dissolved agent and anti-
and turn off the tap after washing to avoid to	septics should not be used to
produce damp and strange smell in the drum.	clean the surface of the ma-
If the washing machine is not going to be used	chine and rube apares. Only
for a long period of time, put the drainage hose	the clothing soaked with some
as lower as possible to let the water in the pipe	soap liquid is suggested.
out for avoiding the water turns bad quality and	Warning: Remove the power
then put the pipe to the original place.	socket before the cleaning.

Check attachments and materials

Name	Operational	Quality	Water	Drain	Plastic
	manual	certificate	hose	holder	plugs
Quantity	1	1	1	1	3

Remove the packing screws as shown in Fig.2.

The packing bolts protect the appliance from impact damage during transportation. Follow the steps below before using the appliance.

1.Remove the rear panel of the washing machine;

2.Remove the three packing bolts from the rear panel of the washing machine, the rubber hose and then the shock ablorption steel channel;

3.Refit the back plate;

4.Fill the holes left by the packing bolts with plastic plugs.

(Attention: the packing bolts and rubber hose should be kept in a safe place for later use )

There is a plastic jacket packing the door catch, please remove it when you unpack the machine. Do not let children touch it to void

dangerous things.

Fig.2

Adjusting the position of the washing machine.

The washing machine is provide with adjustable feet. Before use, adjust the feet until the appliance is level, as shown in Fig.3.

Fig.3

3. Clean the detergent	4. To prevent blockages to the
cartridge regularly:	water supply or the ingress of
Pull the detergent cartridge	contaminants, clean the water
up and out then wash it out.	inlet and inlet water filter
Put it back when it is clean.	regularly.
5. Clean the filter ( once a month )	6. If the machine is to be moved a distance
Press the lower edge of the filter compartment
	location, replace the vibration mounting locks
cover to open; ( Fig.1-2 )
	which were removed during installation as
Remove the filter by turning counterclockwise;
	shown below.
( Fig.3 )
Flash clean with running water;
Filter replacement is the reverse of removal.
Caution: Attention shall be paid to ensure that
the filter is replaced correctly to avoid possible
leakage.		Remove the	Replace the
Using a flat-nose screw driver prizes the slits
		back cover	rubber plugs
of two ends of the button panel and move the
panel out with your hands. ( Fig.4-5 )

			Insert the channel	Tighten the bolts
Fig.1	Fig.2	Fig.3	steel vibration locks	with a spanner
			insert the bolts

Fig.4 Fig.5 Replace the back cover

7.Remove the power plug and turn off the tap and open the door if the machine is not going to be used for a long period of time. With the method there would not be any bad smell inside the tube.

4 13