Maintenance
To prevent blockage to the water supply by ingress of foreign
substances, clean the water inlet valve and inlet valve filter regularly.
Maintenance or service wash
A maintenance wash is done to clean the washing machine out by running
a
kills off bacteria and unwanted fungal growth. A service (or maintenance) wash involves pu
washing machine on the hoest wash (90°C Coon Wash) with only the detergent inside - and no laundry. If you normally use a washing machine detergent that doesn't contain bleach, then buy some detergent that does, and use it for your maintenance washes. This will help kill off bacteria and prevent black mould and grease.
Tip: Look for something like, "bleaching agents" in the ingredients. Do not put cleaning bleach (for example “Domestos”) in the washing machine this will damage the machine. There are certain types of bleach example oxygen bleaches like “Vanish” that are appropriate for laundry. To check if your washing machine is being badly affected, carefully examine the inside of the door seal for slime. Pull the lip in front of the drum and look underneath on lip of the tub as it can accumulate a slime, which causes smells, and rots the seal.
Moving the machine
If the machine is to be moved to a distant lo | on, replace the transpo | on bolts removed before | ||||
in | on to prevent damage as shown below. |
|
|
|
| |
Remove the back cover. |
|
|
|
|
| |
Remove the blanking plugs. |
|
|
|
|
| |
Insert the synthe c stabilizers and the transpo | on bolts. |
|
|
|
| |
Tighten the bolts with a spanner. |
|
|
|
|
| |
|
|
|
|
| ||
Replace the back cover. |
|
|
|
|
| |
Long periods of disuse
If the washing machine is l
idle for a long period, pull out the electrical plug and turn off the water supply. Open the washer door to prevent form
on of moisture and odors. Let the door open while not used.
Display Codes
Display Codes and Special func
ons
Codes
Err1
Err2
Err3
Err4
Err5
Causes |
|
|
|
| Solu ons |
| |
|
|
|
|
|
|
|
|
Door is not properly shut. |
|
|
|
| Shut the door properly, and then press the |
| |
|
|
|
|
|
| Start/Pause bu on. |
|
Drainage error, water not emp | within |
| Clean the filter and check the drain hose |
| |||
6 minutes. |
|
|
| for blockage. If error s l exists, please |
| ||
|
|
|
|
|
| contact the maintenance personnel. |
|
|
|
|
|
|
|
|
|
| Temperature sensor not properly |
|
|
|
| Contact the maintenance personnel. |
|
| connected or damaged. |
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Heater error (Appears at the end of a |
|
| Contact the maintenance personnel. |
| ||
cycle). |
|
|
|
|
|
| |
| Water level not met in 8 minutes. |
|
|
|
| Make sure that tap is turned on, and water |
|
| The height of the drain hose is below 80 |
|
|
| pressure is normal. |
| |
| cm. |
|
|
|
| If problem s ll exists, please contact the |
|
| The drain hose is in water. |
|
|
|
| maintenance personnel. |
|
|
|
|
|
|
| Install drain hose within |
|
|
|
|
|
|
| height. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Make sure the drain hose is not in water. |
|
|
|
|
|
|
|
|
|
17