Haier Haier washing machine user manual Adjus ng the b om cover, Dismantle the transport on bolts

Before Use

Inon

Adjusng the bom cover

Before removing the transpoon bolts, please fix the boom cover to the boom of the washing machine. Lay down the machine (fig.1), unscrew the feet and fit the boom cover with the four holes corresponding to the screw holes of the feet. Then screw the feet back on through the cover and fix it thus securely to the boom of the machine (fig 2.).

It keeps out the dampness and reduces the noise.

Dismantle the transporton bolts

The transpoon bolts are designed for clamping an- vibon components inside of the washing machine during the transpoon process.

Remove the back cover.

Remove the four bolts on the rear side and take out

the sync stabilizers from within the machine.

Replace the back cover.

Fill the holes le by the bolts with blanking plugs.

Note:

When you replace the back cover, the convex must face to outside, and you have to insert the back cover from the two gaps as shown in fig.5. Keep the transportaon bolts and synthec

stabilizers in a safe place for later use.

5.

Adjusng the feet

There are adjustable feet under the boom of the washing machine. Before use, they should be adjusted so that the machine is level. This will minimize vibrons and thus noise during use. It will also reduce wear and tear. We recommend using a spirit level to level the appliance. The floor should be as stable and flat as possible.

6