Installation and Adjustment
Please install and adjust the machine according to the directions contained in this manual. It is very important to follow these directions for the safe operation of the machine, and to ensure your machine operates correctly.
Install the bottom plate
The purpose of the bottom plate is to suppress noise from the washing machine during operation.
Steps:
1.Lay the washer on its back, on a
2.Place the plate on to the bottom of the machine.
3.Use a screwdriver to tighten the screw ( in accessory bag) securing the panel to bottom of the washer.
4.Once the screw is tight and the panel is secure, return the washer to its standing position.
Screw
Bottom plate
Front
Back
Carpet
Balance washing machine
Do not install this machine on an incline greater than 2° . Installing machine on an angle or on rough ground will result in unstable running or stoppage of the machine. Please adjust it by the following method:
1.Confirm it is level；
2.Lift up the side of the leg slightly and twist the adjustable leg.
Note:The distance between the washing machine and wall:at least 20 mm.
| 20mm | 20mm |
High | Low |
|
Installation of drainage hose
Install drainage hose
First connect the drainage hose to the connection point on the lower | Drain hose neck guide | |
right side of the cabinet, and fasten with drain hose clamp (provided). | ||
|
Connect drain hose guide on to the outside of drainage hose. To guide |
| ||
the drain hose over the tub or standpipe the hose guide MUST be fitted |
| ||
to the drain hose. |
| Drain hose | |
Drain hose joint | clamp | ||
| |||
Placement of Drainage Hose
The height of the standpipe or tub should be between 850 - 1200 mm. |
| |
To avoid syphoning, the drain hose should not extend more than 20 mm |
| |
from the end of the guide. | 0.8m h 1.2m | |
Ensure drainage hose is held in place to avoid leaks or spills. | ||
|
4