Washing sequence
Wash timer
(To set to below 2 minutes, first set to 6 minutes then turn it back.).
Function selector | Drain switch | ||
| |||
(Soft | current, | Not set the switch to | |
DRAIN during washing | |||
Standard current) | |||
| |||
STANDARD | STANDARD | OFF | |
| |||
SOFT | SOFT |
| |
DRAIN
CALEFACTION
Spin timer
(To set to below 1 minute, first set to 2 minutes then turn it back. it can increase the service life of the timer).
OFF
1
42
|
|
| |
WASH TIMER | FUNCTION SELECTOR | DRAIN SWITCH | SPIN TIMER |
Wash
1 Set the water inlet selector at the "WASH" side. (Figure 1)
2 Set the water level adjusting lever to needed line.
2.Fill the water and add the dissolved washing powder to make the water level reach the preset position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
|
|
| STANDARD |
Page7 |
|
| SOFT |
|
|
3.Put in the laundries. If the water quantity is insufficient, please add water.
4.Select the current.
Select the strength of the current according to the laundries. (Figure 3)
5.Select the washing time
Select the washing time according to the laundries. (Figure 4)
6.After washing, set the "WASH SELECTOR" at "DRAIN". (Figure 5).
WASH | SPIN |
WATER INLET SELECTOR
Figure 1
Figure 2
STANDARD
SOFT 
CALEFACTION
Figure 3
FUNCTION SELECTOR
Figure 4
WASH TIMER
OFF
DRAIN
Figure 5
DRAIN SWITCH
8