Install the water inlet hose
Confirm the water faucet
Water faucet,suitable | Water faucet,not suitable |
Outlet end surface |
|
>10mm |
|
It is required that the front end shall be longer than 10mm.
The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage.
Reserve, remain time digitron
It displays
It displays remained reserve time (hour).
It displays total remained time (min). If the total time exceeds 99 minutes, it uses "A" on tens digit to represent100 minutes, and uses "b" to represent 110 minutes. E.g. "A3" represents 103 minutes.
It displays abnormal symbol in abnormal situation. (See to Page15)
"Power" button
Push the "power" button to switch on the power.
Under 
Push the "power" button to switch on the power. If the "start/pause" button is not pushed, the machine will switch off the power automatically after 5 minutes.
Connection between the water inlet hose jointer and the water faucet
1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1.
2.Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet, please loosen the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth,
otherwise it may leak water. See to Figure 3.)
Reserve
•
••
•
•
•
•
•
•
•
•
Water level
Standard |
| Normal |
| Tub dry |
|
|
|
|
|
Fibre |
| Quick |
|
|
|
|
|
|
|
Cotton |
| Posthaste |
|
|
|
|
|
|
|
|
|
|
| |
Woollen |
| Jean |
|
|
r Powe
y bdr Tu
Program
TUB DRY 
button
Push the"TUB DRY"button,the indicator is lighted,and the"TUB DRY" function is operating. the"TUB DRY" can not be selected after the "program" button have been selected. 
After washing,the innerand outer
tub is wet,mildew may grow not using for a long time.Then,the
water inlet hose jointer
Slider
Screw
Sign plate
"TUB DRY" fuction can make the tub dry preventing mildew from growing.
Lock level
Screw knife
Bushing
water inlet hose
Figure 1
Figure 2 | Figure 3 |
WATER LEVEL 
button
PROGRAM 
selection button
3.Fasten the four screws evenly. See to Figure 4.
4 Take off the nameplate. Twist the fastening nut as per the indication of the figure to seal up the exit end face of the faucet. See to Figure 5.
remark: Before installation, the threading is 4mmabove the upper surface of the nut.
After installation, the threading is 2mm above the upper surface of the nut. See to figure 6.
About 4mm before twisting
About less than 2mm after twisting
Screw nut
Figure 4 | Figure 5 | Figure 6 |
"Reserve" button
The digitron displays remain time before washing is finished (in minutes)
Push "reserve" button, the digitron displays the reserve time of washing (in hours). The indicator flashes to indicate that the reserve function
is operating.Push "reserve" button to displaythe reserve mode.
The washing machine can detect the laundries automatically.
After detection, it will set the water level to suitable value among 4, 6, 8, and 10 automatically.
You can also set water level by yourself. After the machine is started, it
will not set water level automatically. You shall push the start/pause button to make new setting.
If there's water inside the tub, the machine cannot detect the laundries and will display water level 6 .
If wet laundries are put in, it may display water level 10 . You must set suitable water level by yourself.
If POSTHASTE programs selected, it will display water level 3 .
When water level 2 is reached in water filling, it will perform washing while filling water. When water level 3 is reached, it will change to normal washing.
During operation of wash and rinse program, you can push down the water level button to add water. When you release the button, or it reaches the overflow water level, the machine will stop adding water. 
The water level decided may be different from actual value because of the different moisture level of the laundries.
Following automatic programs are available for selection
PROGRAM | Applicable situation |
|
|
STANDARD | Common washing |
QUICK | Quick and |
laundries | |
POSTHASTE | Super quick wash of the laundry under 1 kg |
with light soil | |
JEAN | Washing the relatively big and thick laundries |
FIBER | Washing the chemical fiber laundries |
COTTON | Washing the cotton textiles |
WOOLLEN | Washing the woolen textiles |
NORMAL | Common washing |
|
|