Haier HWM80-113S-Fiji user manual Trouble-shooting Answers to question

Page 17
Spin tub

Trouble-shooting Answers to question

If the laundries fall to the outer side of the spin tub

If the laundries fall to the outer side of the spin tub, please take them out immediately.

1.Dismantle

As indicated in the figure, push the point marked with " " to pull the spin tub frame to oblique upwards to dismantle it.

2.Install

After install the back edge of the spin tub frame to proper position, push the four points marked with "" by force to reset it.

Please check carefully. The laundries may fall to the lower part of the outer side of the spin tub (as indicated in the figure).

If the laundries fall to the outer side of the spin tub, during spinning the draining will get blocked and the rotation speed of the spin tub is reduced.

Spin tub frame

Laundries

When the remained water is frozen

Prevent the freezing (be sure to discharge the water completely after using)

After complete draining, set the "WASH SELECTOR" at "STRONG" or "STANDARD". If it is set at "DRAIN", it will be rather difficult for the frozen water to melt.

When the water is frozen

Pour hot water below 50 into the wash tub to soak it completely. Then turn the pulsator with hands gently. Please confirm the drainage can work normally before next using.

Below 50 c 2~3L

15

Image 17
Contents Twin-tub Washing Machine Contents Names of the parts ¸ ÷ ² ¿ Î » Ã û ³ ÆEarth × ¢ Ò â Ê Â Ï î Safety precautionsInstall the lint filter Installation and adjustmentHow to change the direction of the drain hoses Install the water inlet hose Select the water level ÏPreparation´ Ç before× washing¼ ± ¸ ´ µ Ó ¼ Á µ Ä Ê ¹ Ó Ã ´ µ Ó Ð ë Ö ªMusts in washing Usage of the detergentWashing sequence Midway spinning Rinse with water-filling RinsingSpinning ÏDisposal´ º óafter´ washingÀ í Cleaning the lint filter´ º ó ´ À í Cleaning the overflow filterTrouble-shooting Answers to question Trouble-shooting Answers to question ×Packing Ï älistË µ Ã ÷ Specification