Haier XQB50-68 Common phenomena, Phenomenan Reason How to settle, Phenomena Explanation

Trouble-shooting Answers to question

(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself.

	Phenomenan			The reason		How to settle
	In spinning, the machine stops
	running. (The "wash" "rinse"			The top lid is not closed.		Close the top lid.
	"spin" indicator flash quickly)
	The draining does not work,			Is the drain hose blocked		Clean the foreign material.
	or the speed of draining is
	too slow	( the indicators of		by foreign material?		Open and close the top lid once.
	"rinse"	"spin" flash)
	The safety switch acts. The			Are the laundries put		Re-order the laundries.
	spinning can not work (the			slantingly?		Close the top lid.
	indicators of "wash" "rinse"			Is the machine slanting?		Level the machine in right position.
	flash quickly)					Open and close the top lid once.
	The program pauses after			The water faucet is not open.		Open the water faucet. Push
						the "Start/Pause" button.
	about 15 minutes of water
				The water inlet valve is		Clean the water inlet valve.
	inlet (the indicators of "wash"
				blocked		Push the "Start/Pause" button.
	"spin" flash quickly)
						Wait for the normal water
				The water pressure is too low
				and the current is too small.		pressure before use.
				Is there power failure?		Use it when the power is on.
			No wash	Is the power plug loose?		Insert the power plug tightly.
				If water level reach the appoint level?		Affusion to appoint level.
	The machine does
	not act.			Is the power plug loose?		Insert the power plug tightly.
			No spin	Is the top lid is not closed.?		Close the top lid
				Are the laundries put		Re-order the laundries.
				slantingly?		Close the top lid.
	There's abnormal sound			Is the machine slanting?		Level the machine properly.
	inside the machine.
				Are the laundries slanting		Re-order the laundries.
				in spinning?
	The water faucet leaks.			Is the jointer screw of the		Fasten the jointer screw
				water inlet	hose is loose
						properly.
				or twisted awry?
Common phenomena
		Phenomena			Explanation
					Balance the laundries to avoid slanting.
	The spinning is intermittent when it starts.
	Push the "Process selector" button to				The program is setting the drain time. Some
	select "Spin", but it doesn't work.				time is needed before it starts spinning.
	There may be some water flowing out of				It is the water remained in the factory
	the drain hose in the first use of the machine.				inspection of performance.
	In the final spinning, it stops and displays				It is because that the laundries are slanting
					to one side, and the safety switch acts. After
	"Rinse", and starts water inlet.
					water inlet and	stirring, the slanting will be
					removed and the spinning will work.