Haier AWT-80LI specifications Install the water inlet hose Select the water level

Washing sequence

How to change the direction of the drain hoses

Wash timer

(To set to below 2 minute, first set to 5 minute then turn it back. it can increase the service life of the timer).

OFF

153

126

WASH TIMER

9

Âé

Wash selector

(Strong current, standard current)

STRONG

STANDARD

DRAIN

WASH SELECTOR

Spin timer

(to set to below 1 minute, first set to 2 minute then turn it back. it can increase the service life of the timer).

OFF

51

42

SPIN TIMER

3

Figure 1 indicates the ex factory installation

Side sectional view

position of the drain hose.

		Drain hose	Fixing hook
Extend the drain hose from the side of spin tub.		fixing hook	installation hole
		Pull outwards	Drain hose
Take off the drain hose from the hanging		slightly
hole of the cabinet. Pull the drain hose		Take off
fixing hook outwards gently to take out		the drain hose
the drain hose from the two fixing hooks.	Figure 1	Drain hose	Figure 2
(As per Figure 2)		fixing hook

Rotate the drain hose fixing hook for 90 to take it out from the installation hole (As per Figure 3).

Wash

Install the two drain hose fixing hooks taken out into the installation hole at the other side of

1 Inlet selector

(1) Set inlet selector to Wash side. Figure 1

(2 )Adjust water level rod to a position as needed.

2.Fill the water and add the dissolved washing powder to make the water level reach the preset position. (Figure 2)

Run washing program for some time to stir and dissolve the powder completely.

WASH SPIN

Figure 1

Figure 2

STRONG

the base frame (to aim at the installation hole accurately you can lean the washing machine forward slightly).Then rotatefor 90 (As per Figure 4).

Pull the fixing hook outwards slightly. Inlay the drain hose into the fixing hooks reliably along the groove at spin tub side, and make it extend towards spin tub side..

Then hang the drain hose into the hanging hole at the spin tub side. (As per Figure 5).

Extend the drain hose from the back side

Rotate the fixing	Rotate the fixing
hook for 90	hook for 90
	to fix it
Take off the fixing	Insert the fixing hook into the
hook downwards
	installation hole upwards
Figure 3	Figure 4

3.Put in the laundries. If the water quantity is insufficient, please add water.

STANDARD

DRAIN

Figure 3

Take out the drain hose from the two fixing hooks.	Figure 5
make it extend towards back side.(Extend the drain		Figure 6
hose from the side of back, hang the drain hose in
to the hanging hole at the both sides) . (As per Figure 6).

4.Select the current.

Select the strength of the current according to the laundries. (Figure 3)

5.Select the washing time

Select the washing time according to the laundries. (Figure 4)

OFF

153

126

Figure 4

9

Install the water inlet hose; Select the water level

Insert the water inlet hose into the water-filling Water inlet hose entrance on the control panel directly.(pull it

out to dismantle it)

Select water level according to the

STRONG

6.After washing,the buzzer will ring .Set

the "WASH SELECTOR" at "DRAIN".	STANDARD
(Figure 5).	DRAIN

quantity of the laundries.

Set the water level adjusting lever to needed line.

Use the new water inlet hose provided

Water level indicator

Maximum Max.

Med

Figure 5

with the machine to connect to the water faucet.Old hose sets should not be reused.

Medium

Minimum

Min

8

5