Safety precautions
Please insert the power cord into special rece- | The power cord plug should be convenient |
ptacle with rated voltage.If the power cord is | to be pluged in or pluged out with hand |
while the washing machine runs normally. | |
eptacle.The earthing terminal of the receptacle Be sure to pull the plug out and close the | |
must be earthed reliably.If it is | water tap when the machine is idle,when |
please guarantee that the earthing wire is ear- | moving the machine,or when cleaning |
Disposal after washing
After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine.
Please first pull off the power plug from the receptacle before cleaning.
thed reliably.If possible ,please adopt electric | the machine.Do not use wet hand to ins- |
leakage protector. | ert or pull out the power plug. |
The lint filter must be used during washing. It must be cleaned in time after each using.
Lint filter:
1.Push down the spring piece of the top lint filter to make the claws out of the filter cover, and then pull out the lint filter to get it down. 
figure1 
Up
Install
Dismantle
Down
Do not damage the power cord,bend ,extend,twist,bind or alter it by force.Do not press or nip it with weight.If the power cord or the power plug is bad, or the power plug becomes flexible,to avoid risk it is required to have it replaced by the technicians of our special shop or the costomer care agent. Keep the pin of the power plug clean,if the
power plug is polluted with dust,please wipe with dry cloth carefully.
2.Pull the back of the lint filter, and then you can get down it off the front cover of the lint filter. 
figure2 
3.Sweep the rubbish in the lint filter.
4.Put the back of the lint filter into the front cover .
Figure 1
The back cover of lint filter
Dismantle
Up
Do not put the machine at damp place like | Do not use water hotter above 50 C . | |
the bathroom. Never wash it with water. | ||
| ||
Not put wet laundries on the control panel. |
|
5.Put the lint filter into filter cover, and make it tight . 6.Make sure the lint filter well installed, or it can
influence your use.
Install
Down
The front cover of lint filter
Figure 2
The filter screen of the water inlet valve is likely to be | If the cabinet is dirty, wipe it with wet cloth |
blocked by foreign materials and influence the water | Do not flush it directly with water. |
inlet. | Wipe it with neutral detergent. |
Please clean it with brush every two months. | Do not wipe it with thinner, petrol, alcohol etc. |
|
In case the washing machine is installed on ground with carpet, do not block the ventilation hole with carpet.
The ventilation holes at the bottom
soft items
Do not wash
1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose).
2.Do not store water in the washing machine for a long period. Drain the water completely after each using.
3.Be sure to pull off the power plug before maintenance.
Do not let the machine share one receptacle with other electric appliances. If the power plug is damaged, or the plugging into the receptacle is loose, do not use the plug any more.
2
4.Hang up the power cord and drain hose.
5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time ( about 1 hour), then close the top lid.
15