Haier WNA600TX manual Connecting WaterSupply

Page 8

Installation

Connection of Connect the drain hose to a drain duct (with internal the Drain Hose diameter of at least 4 cm.) or place it for drainage into a sink or a tub, ensuring that there are no kinks or bends. The free end must be at a height of between 80 and 100 cm. Should it be necessary to fix the end of the hose at a height of less than 80 cm from the floor, the hose must be fixed in the appropriate hook on the upper part of the back panel (Fig.4) or use the

supplied support to fix the drain hose.(Fig.5)

Fig.4

Fig.5

 

Connecting WaterSupply

Insert stainless steel screen washers into end of each supply hose and attach that end of supply hose to your 3/4" water tap spigot.Be sure that you match up cold water to "C" .Note:Home Centers also have"Y" connectors and "Couplings" which enable you to connect the machine to your sinks faucet.

Image 8
Contents T O MAT IC DR U M WA S H ING MA C H INE Page 11-15 17-18Function Introduction Characteristics of WNA600TX Installation Unpacking levelling and positioningElectric connection Connection of tap and Loading HoseConnecting WaterSupply Close up Close up Close up Weight is right Laundry hasBeen loaded CorrectlyBeen chosen CorrectProgramme has Detergent has been put in properly Never place bleach in the other compartments Cycle is started Wash is finishedMaintenance five simple precautions for this machine Washing machine wont start WashingMachine wont Fill with waterVibrates too Much whenSpinning Stops operatingGuide for selecting programme Page Wiring Circuit WNA600TX Page 0020505064B