Installation and adjustment

Install the lint filter

After openning the package,please take out the lint filter from the document bag,install it to the filter frame of the cabinet.See to the figure.

Soft item

Drain hose fixing clamp

2.Do not step on or press the drain hose.

<10cm

1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause incomplete drainage.

Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.

How to change the direction of the drain hoses

Usage of the drain hose

The drainage shall be smooth with the drain hose. 3 If the drain hose is too long, cut it at mid

point. To make smooth drainage, cut the front end of the hose slantingly.

4.If extra drain hose is needed , the inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed

1.5m.

> 30mm

<1.5m

overflow filter

lint filter

Figure 1 indicates the ex factory installation position of the drain hose.

Soft item

Extend the drain hose from the side of spin tub

Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. Take off the drain hose from the cabinet. Dismantle the drain hose fixing clamp and take the hose out of the fixing groove.

(See to Figure 2).

Embed the drain hose into the groove along the side of the spin tub in the order of (1)~(3), heading for the side of the spin tub. (See to Figure 3).

Back

Front

Figure 1

Figure 2

Install the water inlet hose; Select the water level

Extend to the

	Use the new water inlet hose provided with the
	machine to connect to the water faucet.	Water-filling
	Old hose sets should not be reused.
		entrance cover

Water inlet hose

Embed the drain hose into the groove with hands. Take care not to damage the drain hose in fastening the fixing clamp.

spin tub side

Embed into the groove in turn

Figure 3

Insert the water inlet hose into the water-filling entrance on the control panel directly. (pull it out to dismantle it)

Water-filling entrance

Extend the drain hose from the rear side

Select water level according to the quantity of the laundries.

Attention:

In water filling, do not exceed

Maximum

Max

Dismantle the drain hose fixing clamp.

Take out the drain hose from the fixing groove. Extend it from the rear side as per the direction of the arrow. (When the drain hose is extended from the rear side, it can be hung on the point

the"Maximum" water level. Otherwise the water may overflow out of the

Medium

Med

for drain hose at the two sides of the cabinet.)

Figure 4

washing machine.

Minimum

Min

(See to Figure 4).