Trouble-shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or
Phenomena | The reason |
| Is there power failure? |
The machine does not act. | Is the power plug loose? |
Spinning
1. Put the laundries into the spin tub Selection of the spin time list 3
evenly and smoothly. |
| Spin time |
| Laundries | |
| (minutes) | |
|
|
| Is the pulsator twisted by foreign materials? | |
|
| |
| Is the drain hose put down? | |
The draining does not work | Is the drain hose frozen? | |
| Is the drain hose blocked by foreign material? | |
|
| |
There's abnormal sound | Are there hair pin, coins or metal items brought | |
during washing | inside the tub? | |
|
| |
There's abnormal sound | Is the machine slanting? | |
and violent vibration | Is the gland pressed evenly? | |
during spinning | Are the laundries in spin tub too much? | |
|
| |
There may be some water | It is the water remained in the factory inspection | |
flowing out of the drain | ||
of performance. | ||
hose in the first use of | ||
| ||
the machine. |
|
2.Press the gland in the tub properly. Close the inner and outer cover of the spin tub.
3.Spin
Select suitable spin time according to the laundries, and do spinning.
During spinning, if there's abnormal sound, it is generally owing to slanting placement of the laundries. Please stop the machine and
Bed sheet or | About 4~5 | |
blanket | ||
| ||
Underwear | About 2~4 | |
(knitwear) | ||
| ||
Swear | About 1~2 | |
(chemical fiber) | ||
| ||
Blending thin | Within 1 minute | |
laundries | ||
|
When the remained water is frozen
Prevent the freezing (be sure to discharge the water completely after using)
After complete draining, set the "WASH SELECTOR" at "STRONG" or "STANDARD". If it is set at "DRAIN", it will be rather difficult for the frozen water to melt.
When the water is frozen | Below |
| |
Pour hot water below 50 | into the wash tub |
to soak it completely. Then turn the pulsator with hands gently. Please confirm the drainage can work normally before next using.
In spinning, it will pause the work if you open the outer cover of the spin tub. Close it to resume the spinning.
To do spinning and draining together,
please first do spinning for around 1
minute, then do draining. Otherwise
the spinning will stop owing to too much
water stored in the spin tub.
14 | 11 |
|