Operating | Your | Washer |
| ||||
In This | Section | Pap0 |
|
| WiP | ||
Baton l brting |
|
|
|
| |||
your | washer | Sekting a cycle nd time | 7 | ||||
Starting or stopping | your washer | .5 | Using rinse md | spin | 6 | ||
Selecting | a load | size | ......................................... | .5 | What happena | in each cycle | 6 |
Selecting | a wash temperature | .6 | Using tha chlorine bleach dispm~~ | .S | |||
Operating your washer properly assures maximum washing eff
Before starting your washer
Add measured detergent. Then place a sorted load in the washer before starting.
See page 10 for additional “Beforeyou wash” information.
Starting or stopping your
Startlng your washer:
1.Select a load size (see below).
2.Push in the Cycle Control Knob and turn it clockwise. Stop when the indicator on the knob’s outer ring points to the number and wash water temperature in the cycle you
want. The numbers are minutes of wash time. Wash water temperature is indicated
by the letter near Fill (H=Hot, W=Warm, GCold). (See pages
3.Pull out the Cycle Control Knob.
Stopplng and restarting your washer:
lTo stop the washer at any time, push in the Cycle Control Knob.
lTo restart the washer, close the lid (if necessary) and pull out the Cycle Control Knob.
washer
Wash water bmparature
4
a
I
Wash time
Selecting a load size
Position the Load Size Selector at the setting that corresponds to the size load you want to wash. Select a setting based upon the size of the load and the fabric you are washing. See pages 10 and 11 for additional loading information.
To change the load size setting after the washer has started to fill, move the Selector to the desired new setting.
Load size tips
lItems should move freely during the wash. Do not overload the machine or select a load size that is too small for the wash load.
lUse the Large load size setting for best results with permanent press clothes.
l Reduce wash time when using the Small load size setting. Loads with only a few
small items need less wash time.
5