OPERATING THE DRYER
Once you have loaded the dryer:
1Press the ON/OFF button to turn on the dryer. The lights around the cycle
selector knob will illuminate.
2Turn the cycle selector knob to the desired cycle. The display will show
the preset Dry Level, Temperature, Time, and Option settings for that cycle.
3If you would like to change the settings for that cycle, such as the dry level or temperature, press the appropriate cycle settings button(s) until the indicator light for the desired setting is lit.
NOTE: To protect your garments, not every dry level, temperature, or option is available with every cycle.
4Select any additional cycle options, such as WRINKLE CARE, ANTI BACTERIAL, or DAMP DRY BEEP, by pressing the button for that option. The indicator light on the button will light to show that option has been selected. To deselect an option, press the button again.
NOTE: To protect your garments, not every dry level, temperature, or option is available with every cycle.
H O W TO U S E
5Press the START/PAUSE button to begin the cycle. The display will change,
and the dryer will display the estimated (SENSOR DRY) or set time (MANUAL DRY) remaining
and start tumbling. To pause the cycle at any time, for example to clean the lint filter or to remove a garment, open the dryer door or press PAUSE. To resume the cycle where it was stopped, press START/PAUSE again.
NOTE: If the dryer has been stopped for more than 8 minutes, the dryer will turn off automatically.
6When the load is finished, the beeper (if set) will sound. If you have set the Wrinkle Care option, the dryer will tumble the load periodically for up to 3 hours.
To prevent wrinkling, remove items from the dryer immediately after the end of the cycle.
7Always clean the lint filter after every cycle.
To clean, pull the lint filter straight up and roll any lint off the filter with your fingers. Do not rinse or wash the filter to remove lint. Push the lint filter firmly back into place.
25