Frigidaire 137409900A(1111) Cycle Selection, For best results, Operating Instructions, initial

Page 7
Cycle Selection

OPERATING INSTRUCTIONS

This manual covers many models and not all cycles, options, or features listed are available on every model. Console shown above for reference only. Your model may differ.

Cycle Selection

Turn the cycle selector in either direction to the cycle desired.

For best results

Follow the fabric care label instructions on items

to be dried.

Once a cycle is running, turning the selector knob to another selection will not change the cycle. If cycle selection change is attempted after the cycle starts, the indicator lights will flash and a signal will beep, but the original cycle will continue.

NOTE

To change the cycle selection once the cycle has begun, push in and hold the cycle selector knob to cancel the current cycle, make the new selection and push in the selector knob again to restart the dryer.

Auto Dry Cycles

Auto Dry cycles take the guesswork out of selecting the correct drying time for each load. Moisture sensing bars at the back of the dryer drum sense the moisture level of the load as it tumbles through the heated air. With Auto Dry cycles, the load will automatically be dried at the selected temperature to the desired dryness level. Auto Dry cycles save time and energy and protect fabrics.

The estimated drying time will be displayed for about 5 minutes. Then the outside of the display will light up in a circular track to indicate the drying time is automatically being determined by the sensors. When the load has reached the selected dryness level, it will continue to tumble during a cool down period. This helps reduce wrinkling and makes items easier to handle during unloading.

1. initial

2. calculating

3. estimated

Drying time varies depending on size and dampness of load and fabric type. If the load is too small or almost dry, the moisture sensing bars may not detect enough moisture to continue the cycle and the cycle may end after a few minutes. If this occurs, select a Timed Dry cycle.

Room temperature and humidity, type of installation and electrical voltage or gas pressure can also affect drying time.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents All about the WarrantyCare and Cleaning Use &CareProduct Record IMPORTANT SAFETY INSTRUCTIONSRecognize safety symbols, words and labels DefinitionsFIRE HAZARD WARNING - RISK OF FIRE240 v Electric Dryer PREVENT FIREPREVENT INJURY PROTECT CHILDRENPREVENT INJURY AND DAMAGE TO THE DRYER A D C B OPERATING INSTRUCTIONSNormal Operating Sounds Operating Your Dryer6 When the cycle ends, remove items immedi- ately and hang or fold Operating Your Dryer, continued2 Check that the lint filter is clean and in place 4 Select the appropriate cycle and settings for each load1. initial Cycle SelectionFor best results Auto Dry Cyclesheavy duty Cycle Selection, continuedcasual normalhigh Cycle Settings For best resultsDrying Temperature sanitizeshrink guard Cycle Optionsenergy saver wrinkle release= Cycle defaults Dryer Settings ChartEstimated Time Remaining Other FeaturesDrying Rack on select models Control LockINSIDE CARE AND CLEANINGOUTSIDE Common Drying Problems SOLUTIONS TO COMMON PROBLEMSPOSSIBLE CAUSE Avoid Service ChecklistSOLUTION OCCURRENCEIF YOU NEED SERVICE MAJOR APPLIANCE WARRANTY INFORMATIONWarranty Periods This warranty does not cover the following
Top Page Image Contents