Option 1: 3-Wire Connection with a Power Supply Cord
If your local codes or ordinances permit the
connection of a
neutral wire, use these instructions. If your local codes or ordinances do not allow the connection of
a
3-wire connection.
C | g f |
a.
b.
c.Neutral prong
d.Spade terminals with up turned ends
e.3/4 in. ( !.9 cm) UL approved strain relief
f.Ring terminals
g.Neutral (white or center wire)
. Loosen or remove center terminal block screw.
2.Connect neutral wire (white or center wire) of power supply cord to the center, silver colored terminal screw of the terminal block. Tighten screw.
O
O
a.External ground connector
b.Neutral grounding wire (white)
c.Center
d.Neutral wire (white or center wire)
e.3/4in. (!.9cm)
3.Connect the other wires to outer terminal block screws. Tighten screws.
4.Tighten strain relief screws.
5.Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with
16