Fisher & Paykel NZ AU Dryer wall mounting instructions, Tools and parts required

Page 11

Dryer wall mounting instructions

Tools and parts required:

1 x drill and 3 mm bit

1 x Phillips screw driver

2 x wood screws (14 x 50 timbertite screws)

1 x screw driver

1 x helper to lift dryer onto bracket

Extra tools and parts for mounting onto a concrete wall:

1 x 6 mm bit

2 x expanding bolts (M6 x 50)

1 x adjustable spanner

Note: read these instructions in conjunction with venting instructions.

9

1Determine the position of the dryer on the wall and mark the bracket position.

A minimum of 70 mm is needed between the top of the bracket and the ceiling for ease of installation.

If mounting over a washer allow sufficient room to open the lid of the washer or use a lid catch retainer – Part no. 479273.

If the dryer is vented through the mounting wall ensure the venting hole clears any studs.

2Fit the bracket to the wall. Ensure the bracket is securely fastened at both ends (eg. into the stud). Fit a timber slat between the studs to mount the bracket onto if the stud position is too wide.

3Fit the spacers using screws provided. If timber slat has been used with wall mounting bracket, pack spacers away from wall by same amount.

4Mount the dryer on the bracket. Tilt the dryer out from below, engage the bracket in the back panel slots then lower the dryer and rest against the wall.

WARNING!

Weight Hazard

Use two or more people to move and install the dryer.

Failure to do so can result in back or other injury.

5Fit inverted control panel over the existing panel if necessary.

Image 11
Contents Installation instructions and user guide Page Contents Cost to dry Before using your dryerIntroduction Dryer use Safety and warningsSpontaneous combustion LintUpright wall mounting Installation optionsFree standing PlinthExternal venting Installation Electronic and Auto-timer 4.5 kg dryersVenting duct Flush ventingMovable venting Window ventingDirectional outlet grill Installation Auto-timer 3.5 kg dryerSpecifications Dryer positionExtra tools and parts for mounting onto a concrete wall Dryer wall mounting instructionsTools and parts required Floor To reduce creasing Before you drySorting and loading Drying timesAuto-timer 3.5 kg dryer Cleaning the lint filterElectronic and Auto-timer 4.5 kg dryers Airing / Cool down Using your dryerElectronic dryer Dryness levelsDrum reversal Hour settingPausing the dryer Key LockWrinkle free Temperature settingsDelay start Drying cycles Auto-timer dryerLoad comparison Approximate drying times Kg dryers only How to use the drying rackDrying rack Dryer is taking a long time to dry Operating problemsClothes are still damp Pressing START/PAUSE does not start the Electronic dryerPlease keep this User Guide in a safe place Manufacturers warrantyThis warranty does not cover Fisher & Paykel undertakes toProduct details Customer careNew Zealand if you need assistance Australia if you need assistanceCopyright Fisher & Paykel 2007. All rights reserved Header