Electrolux LAVATHERM 56600 operating instructions Permanent connection, Positioning

Page 32

Electrical Connection

The wire coloured green and yellow must be connected to the

terminal marked with the letter “E“ or by the earth symbol or coloured green and yellow

The wire coloured blue must be connected to the terminal “N“ or coloured black.

The wire coloured brown must be connected to the terminal marked “L“ or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

1WARNING: A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely.

Permanent connection

In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

Positioning

To ensure correct operation:

The appliance must be level. Use a spirit level if necessary and adjust the feet to compensate for any unevenness in the floor.

The surrounding area must be kept clean, free of dust and fluff.

Do not install the appliance where the temperature may fall below freezing or rise above 35 °C.

Do not install the appliance on deep pile carpets or obstruct the front ventilation grille, as this will affect the air circulation and could lead to a build-up of heat which would adversely affect the operation of the machine.

32

Image 32
Contents Lavatherm Dear customer Content Before using the appliance for the first timeContent 1Important Safety Information General SafetyInstallation Child Safety3General Information Tumble Dryer 2DisposalPackaging Environmental protection tips Pre-drying Drying processFill weight Duration Power Drying program Description of the appliance Front viewControl panel Before using the appliance for the first time Program selector positionsBrief operating instructions Drying Prepare the laundryOpen the door Load the laundryStart the drying program Removing laundry or loading laundry when necessary Switch-off the dryerEnd of the drying process Removing the laundryEmpty the water reservoir Clean the fluff filter Cleaning the condenserCare symbols R, Q maximum load 5 kg Program tablesTime programs Care symbols R, S1, Q loads less than 1kg Page Cleaning and maintenance Cleaning the filter areaCleaning the drum Cleaning the panel and operating partsCleaning the condenser Symptom Possible cause Solution Something not working?Is the tumble dryer Replace the interior light Door Reversal Instructions Door Reversal Instructions Technical data Electrical Connection Permanent connection PositioningStacking kit Special accessoriesDrainage kit Guarantee Conditions European Guarantee Service & Spare Parts 08705 929Index Acrylate Acrylic AnorakPage Page Subject to change without notice