Operating sequence
Before using your tumble dryer for the first time, we recommend to place a few damp cloths inside the appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1.Connect the appliance.
2.Open the door.
Release the ON/OFF button (the
After each use
•Turn the programme selector dial to “0”.
•Switch the appliance off by releasing the ON/OFF button 
. The
•Clean the filters (see page 14).
Important!
If the drying programme has to be stopped before it
ENGLISH
P1104 |
P1108 |
reaches the end, we recommend that you turn the
programme selector dial to position 
(cooling) and wait until the end of this phase before removing the laundry. This will avoid a
Modifying the programme
To change a programme which is running, first cancel it by turning the programme selector dial to
3.Load the items one at a time, shaking them out loosely.
4.Close the door. Please check the laundry does not get caught between the door and filter.
5.Press the ON/OFF button 
: the
6.Select the drying programme or time.
7.If required, press the low temperature button 
and/or the buzzer OFF button 
.
8.Press the Start button 
for 2 seconds: light 
comes on and drying starts.
The drum turns alternately in both directions during drying.
All drying programmes end with a 10 minute
cooling phase (light 
is on).
You may remove the
laundry after this phase.
9.If the laundry is not removed at the end of the cycle, the dryer performs an
The buzzer sounds every 10 seconds (if the 
button has not been pressed).
Lights 
and 
flash alternately.
If you do not remove the laundry, the dryer will stop automatically at the end of the
Light 
flashes and the
Turn the programme selector dial to “0”; light 
goes out.
“0”. Select the new programme and press the Start button 
.
12