TROUBLESHOOTING
An error made in operation or in the connections is sometimes mistaken for a failure or breakdown. Perform the checks described in the following table before calling in the servicing engineer.
Symptom | Cause |
No power. | Improper connection. |
Magazine cannot | Direction in which it is |
be installed. | inserted is wrong. |
CD is not played. | Disc has been loaded |
| upside down. |
Noise is heard | Large scratches on disc or |
during playback | warped disc. |
or sound is |
|
intermittent. |
|
| Extremely dirty disc. |
| Transit screws still in place. |
| |
| board is installed in wrong |
| direction. |
Remedy
Check connections.
Insert it in proper direction.
Load disc with play side facing up.
Compare sound with another disc. If sound from second disc is acceptable, first disc is defective.
Clean disc.
Remove screws (x 3) on bottom of unit and then use.
Install board in proper direction. (Refer to “installation” in Operating Instructions.)
Error Messages showing on display of controller:
| Cause | Remedy |
Mechanism problem. | Press “RESET” button. | |
| Improper magazine | Eject magazine and try again. |
| installation. |
|
Improper magazine | Eject magazine and try again. | |
| installation. |
|
| Disc has been loaded up | Load disc with label facing up. |
| side down. |
|
| Not original disc. | Try another original disc. |
| Laser lens in high humidity. | Turn on the car and wait |
|
| approximately one hour. |
| Dirty disc | Clean the disc and load the disc |
|
| as instruction manual mentioned. |
www.pyleaudio.com
23
