PYLE Audio PLCD20CH manual Before Installing The Unit, Transport Lock Screws

BEFORE INSTALLING THE UNIT

Transport Lock Screws

The mechanism in the CD changer is

“locked” into place during shipment by the transport screws.

Be sure to remove the screws prior to installation.

Caution

After removing the transport lock screws, place the supplied seals over the screw holes.

These seals are used to keep dust, which could cause a malfunction, out of the unit.

Installation and Wiring Precautions

1. To prevent a short-circuit.

•Be sure to turn off the ignition and remove the negative (–) battery cable prior to installation.

Note

If the changer is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution to avoid causing a short circuit during installation.

2. Do not install the unit in the following locations.

• Locations exposed to direct sunlight.

•Where hot air is discharged from the car-heater.

•When proper installation is not possible and where a great deal of vibration is generated.

3.• Be sure to use the supplied brackets and screws.

•When installing the unit, do not use any screws that are part of the brake or steering system.

4.This unit cannot be installed in any way except that which is authorized (on its side, on its end, at a 45° angle or suspended). Installing it with its side facing down upside down can cause malfunctioning.

6