8use electrolux
5SE
At the end of the program the selector dial must be turned to position O, to switch the machine off.
Attention!
If you turn the program selector dial to another program when the machine is working, the lights or the program progress display start to flash. The machine will not perform the new selected program.
Program Option buttons
Depending on the program, different functions can be combined. These must be selected after choosing the desired program and before depressing the Start/Pause button.
When these buttons are pressed, the corresponding pilot lights come on. When they are pressed again, the pilot lights go out.
Select Delicate
Pressing this button allows drying to be performed at a lower temperature, for delicate items.
The corresponding pilot light comes on. This option can also be used for time controlled drying. DELICATE is only suitable for use with loads of up to 3kg!
When the program has finished the pilot light End/Anticrease is on.
Select the Textile
Press the Textile button repeatedly, to select the desired option. The relevant light will light up.
You can select 2 different options: Cotton Cycle: to be used for cotton.
When the program has finished the pilot light End/Anticrease is on.
Synthetics: to be used for synthetic or delicate items. When the program has finished the pilot light End/Anticrease is on.
Select the Start/Pause
Press this button to start the dryer after having selected the program and the options. The relevant light will stop flashing. If the program selector dial is turned to another position when the machine is running, the buzzer will sound and the program phase indicator lights will flash.
The drum turns alternately in both directions during drying.
All drying programs end with a 10 minute cooling phase (Cooling light is on).
You may remove the laundry after this phase. The lights 
Filter and 
Water Tank illuminate and the buzzer sounds.
If the door of the appliance or the small door at the bottom is opened while the program
is running, this button must be pressed again after closing the door in order to restart the program from the point at which it was interrupted. This button must be depressed also after a power failure and after having reinserted the water tank, if it has been emptied in the middle of a program.